I have some early m20 2.5 pistons.
How would I go about making them lighter ?
could I have the skirts removed.
Ed
lightweight pistons
Moderator: martauto
-
Ant
- Retired Team Member
- Posts: 10496
- Joined: Tue Dec 21, 2004 11:00 pm
- Location: PD+E dept :D
hell yeah,
cut the skirts back on the lathe/mill/whatever so they are just under the line on the inside of the skirts Ed, make sure and take the same amount of each, then weigh them so its a matched set 100%
on high CR slugs its possible to remove almost a third of the stock weight without any detrimental issues.
cut the skirts back on the lathe/mill/whatever so they are just under the line on the inside of the skirts Ed, make sure and take the same amount of each, then weigh them so its a matched set 100%
on high CR slugs its possible to remove almost a third of the stock weight without any detrimental issues.
Product Development and Endurance for Delphi.
Original performance chips, original works not unlicensed copies
Email FTW
Original performance chips, original works not unlicensed copies
Email FTW-
ed325i
- E30 Zone Addict
- Posts: 4146
- Joined: Mon Jan 10, 2005 11:00 pm
Thanks Ant 
I will get them done.
I will get them done.