sunroof panel gasket / dechrome touch up paint

Looking for genuine BMW parts at discounted prices? Try here!

Moderators: martauto, Cotswoldbmw

Post Reply
User avatar
junkjimmy
E30 Zone Newbie
E30 Zone Newbie
Posts: 49
Joined: Thu Nov 16, 2006 11:00 pm

Wed Dec 05, 2007 2:27 pm

Hi dude could you price me for a sunroof panel seal and a dechrome touchup car is an 88 325i thanks
User avatar
zimmerbimmer1
BMW Parts Meister
Posts: 2250
Joined: Sat May 19, 2007 11:00 pm

Thu Dec 06, 2007 3:49 pm

Comes in 2 pieces £55.46

quote ref no 53967 when ordering

We do not do a dechrome touch up unfortunately
Image
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49358
Joined: Mon Jan 10, 2005 11:00 pm

Thu Dec 06, 2007 5:19 pm

Paul, Isn't there a one piece version as well, which is quite a bit cheaper?
54 12 1 903 725, as opposed to 54 12 8 106 928 + 54 12 1 906 999.
User avatar
junkjimmy
E30 Zone Newbie
E30 Zone Newbie
Posts: 49
Joined: Thu Nov 16, 2006 11:00 pm

Thu Dec 06, 2007 8:01 pm

Thats what i was thinking Sytner quoted me £46 +vat for a one piece version
Jay07
E30 Zone Camper
E30 Zone Camper
Posts: 1013
Joined: Sun May 15, 2005 11:00 pm
Location: South London

Thu Dec 06, 2007 10:20 pm

Sorry to jump in ladz, after seeing loads of issues on the zone with sunroofs i decided to take a closer look at mine. on one corner where the rubber that goes around the sunroof dips in and therefore has not been water tight for a while. Some rust has started on the underside. Can you just buy this rubber seal? Is it easy to swap etc.

Much appreciated

Jason
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49358
Joined: Mon Jan 10, 2005 11:00 pm

Thu Dec 06, 2007 11:36 pm

The rust on the underside is arguably caused by the seal being too good. The rust is caused by condensation and insufficient ventilation. The seal isn't intended to be or required to be waterproof - just windproof.
For rust on the underside, take the panel off, treat and paint the rust, remove the centre felt pad, then heat the panel while it is upside down and pour on heated cavity wax.
Pour it in everywhere you can and tilt the panel to get it everywhere inside.
Turn the panel the right way up, and drain the excess wax out while heating the panel with a heat gun.
Clean off the centre area, glue the felt back on, and refit the panel.
Seal just 'rolls off' when the panel is off.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49358
Joined: Mon Jan 10, 2005 11:00 pm

Thu Dec 06, 2007 11:38 pm

Just noticed this in in Paul's forum! Sorry!
User avatar
zimmerbimmer1
BMW Parts Meister
Posts: 2250
Joined: Sat May 19, 2007 11:00 pm

Fri Dec 07, 2007 10:38 am

forgive me if i am wrong

I thought 3 & 4 was fitted to the Sunroof panel and
no 2 was fitted on the body. see link below

http://www.realoem.com/bmw/showparts.do ... g=54&fg=05
Image
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49358
Joined: Mon Jan 10, 2005 11:00 pm

Fri Dec 07, 2007 11:08 am

I've never seen a new 2,3 or 4 in the flesh, but the ETK gives the lengths of the above, and 3 + 4 = 2.
There's definitely no part number 2 fitted anywhere on anyE30 sunroof installation that I've seen.
Chris-W
E30 Zone Team Member
E30 Zone Team Member
Posts: 7219
Joined: Tue May 24, 2005 11:00 pm
Location: South Cheshire
Contact:

Fri Dec 07, 2007 11:33 am

2 is definitely a 1 piece version of the seal.
Image
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49358
Joined: Mon Jan 10, 2005 11:00 pm

Fri Dec 07, 2007 12:22 pm

Chris-W wrote:2 is definitely a 1 piece version of the seal.
Any idea what it was fitted to, Chris? I've E30s right up to 1994, and they all have the two piece.
User avatar
zimmerbimmer1
BMW Parts Meister
Posts: 2250
Joined: Sat May 19, 2007 11:00 pm

Fri Dec 07, 2007 12:23 pm

Sweet will know to quote for the single piece one in the future
Image
Chris-W
E30 Zone Team Member
E30 Zone Team Member
Posts: 7219
Joined: Tue May 24, 2005 11:00 pm
Location: South Cheshire
Contact:

Fri Dec 07, 2007 12:29 pm

Brianmoooore wrote:
Chris-W wrote:2 is definitely a 1 piece version of the seal.
Any idea what it was fitted to, Chris? I've E30s right up to 1994, and they all have the two piece.
Not the first clue - I've never seen a car with one fitted as standard!
Image
Post Reply