V8 engine prices??

Discuss general engine, turbo and supercharger conversions in this section

Moderator: martauto

Post Reply
User avatar
Rickjames
E30 Zone Newbie
E30 Zone Newbie
Posts: 7
Joined: Sat Feb 10, 2007 11:00 pm

Sun Feb 11, 2007 7:02 pm

About how much do these engines go for, M60 or M62?


I cant seem to find any second hand priced engines at all on the internet, are there any special B.M.W. breakers that might do one?
bigdek
E30 Zone Camper
E30 Zone Camper
Posts: 1115
Joined: Thu Feb 10, 2005 11:00 pm
Location: Fife Scotland

Sun Feb 11, 2007 7:22 pm

cheaper buying a complete donor car
User avatar
Rickjames
E30 Zone Newbie
E30 Zone Newbie
Posts: 7
Joined: Sat Feb 10, 2007 11:00 pm

Sun Feb 11, 2007 7:34 pm

That would be a better idea actually, how much did you get yours for if you dont mind me asking? Just been trawling some through of the posts and seen yours, looks very nice.


Was it difficult to fit?
bigdek
E30 Zone Camper
E30 Zone Camper
Posts: 1115
Joined: Thu Feb 10, 2005 11:00 pm
Location: Fife Scotland

Sun Feb 11, 2007 7:36 pm

i bought a stolen rcovered 740 still taxed and mot'd for 300 notes m8.

Got very lucky with a manual box and flywheel for 150.


Sold most of the 740 stuff . the conversion owes me very little so far
User avatar
Rickjames
E30 Zone Newbie
E30 Zone Newbie
Posts: 7
Joined: Sat Feb 10, 2007 11:00 pm

Sun Feb 11, 2007 8:02 pm

That's well cheap!

Bloody hell you got lucky there, one hell of a engine for that price. Handy too with the manual gearbox, they're usually automatic aren't they?
bigdek
E30 Zone Camper
E30 Zone Camper
Posts: 1115
Joined: Thu Feb 10, 2005 11:00 pm
Location: Fife Scotland

Sun Feb 11, 2007 8:48 pm

the 530 and 540 can have manuals m8.

still pretty rare and reasonably expensive to buy when you find one
User avatar
Rickjames
E30 Zone Newbie
E30 Zone Newbie
Posts: 7
Joined: Sat Feb 10, 2007 11:00 pm

Sun Feb 11, 2007 9:16 pm

Yeh, I bet they are. I'm looking at possibly doing this conversion as a trackday project in the near future. Was it difficult to fit the engine in, are there any modifications needed due to the weight of engine or is it just the usual wiring problems etc?
bigdek
E30 Zone Camper
E30 Zone Camper
Posts: 1115
Joined: Thu Feb 10, 2005 11:00 pm
Location: Fife Scotland

Sun Feb 11, 2007 9:56 pm

its a bit of a mare to be honest.

engine is huge in every way

brake servo needs to be relocated somewhere else on the car as there is zero bulkhead space

alternator fouls the chassis rail so you can either notch the chassis rail or fit a smaller alternator.

even with the engine mounted as low as poss it still sits up at the front so subframe spacers are needed to make it sit a bit better.

exhaust manifolds and exhaust need to be fabbed as well.

wiring is straight forward
User avatar
Rickjames
E30 Zone Newbie
E30 Zone Newbie
Posts: 7
Joined: Sat Feb 10, 2007 11:00 pm

Mon Feb 12, 2007 6:34 pm

Not so straight forward to fit then, it is a pretty huge engine mind. It's defnietly something I'm going to look at as a trackday project. Thanks for all the advice Bigdek, it's much appreciated, and fair do's on you for pulling off the conversion too. Take it easy.

Regards, Marc.
Post Reply