Rear window removal and re-fitting
Moderator: martauto
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Hi,
As title, whats involved in removing my rear window?
I need it out for changing my headlining.
Thanks,
Paul
As title, whats involved in removing my rear window?
I need it out for changing my headlining.
Thanks,
Paul
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Thanks Chris. I have just removed everything i need to except the rear window (and its started to rain!), but i am stuck with the window.
You mention 'plastic centre strips'. What are these/where are they located?
Thanks
You mention 'plastic centre strips'. What are these/where are they located?
Thanks
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Thanks. I think i have just realised that these strips are on the outside of the glass, so i need to remove them from outside, then bend these 'L clips' from inside, then push the glass out from inside?
Thanks
Thanks
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
sam325is
- E30 Zone Addict

- Posts: 2002
- Joined: Thu Jul 06, 2006 11:00 pm
- Location: Cheltenham
you need to remove plastic beading from centre of seal like you say, the L shaped plates sit over the top of the beading in the bottom corners on outside, you want 2 people to get it out, one on inside pushing on one outside to stop anything getting damaged when it breaks out of seal, best of getting windscreen fitters to fit beading back in as its quite hard, will probly need new corner plates aswell
-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
OK, thanks guys.
Both back window and windscreen are out, i did it on my own but was careful so all went well.
Oh dear, i didnt know putting it back in would be hard! I will manage in the end im sure
Thanks
Both back window and windscreen are out, i did it on my own but was careful so all went well.
Oh dear, i didnt know putting it back in would be hard! I will manage in the end im sure
Thanks
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Well its a few hours later, and the headlining is mainly done. 'Just' got to do the sunroof section, and the front bit by the windscreen.
The back window is back in, but re-fitting the plastic strips is so hard, Chris, no rhythm has been discovered yet!
The back window is back in, but re-fitting the plastic strips is so hard, Chris, no rhythm has been discovered yet!
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
The tool for refitting the locking strip can be bought for about £8. It's a diamond shaped piece of hard wire on a handle, and it only takes seconds to install the strip when using it.
-
carlos_320i
- E30 Zone Newbie

- Posts: 203
- Joined: Thu Aug 04, 2005 11:00 pm
- Location: Kent
I didnt know it was that easy
Looks like I will be doing this the weekend
-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
http://www.frost.co.uk/item_Detail.asp?productID=8104Brianmoooore wrote:The tool for refitting the locking strip can be bought for about £8. It's a diamond shaped piece of hard wire on a handle, and it only takes seconds to install the strip when using it.
-
ian332isport
- E30 Zone Team Member

- Posts: 5380
- Joined: Wed Dec 22, 2004 11:00 pm
- Location: West Sussex
Getting the strips back in is not very hard with the tool shown above, but the corner pieces are a real turd to fit.
If it aint broke - Modify it...
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Thanks for all the responses. Zone is hugely helpfull.
I have to go to halfords today to get some stuff for my brother, so will look for the tool there.
Hopefully will be done tomorrow.
I have to go to halfords today to get some stuff for my brother, so will look for the tool there.
Hopefully will be done tomorrow.
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
carlos_320i
- E30 Zone Newbie

- Posts: 203
- Joined: Thu Aug 04, 2005 11:00 pm
- Location: Kent
Looks like I wont be doing mine today as it is raining 
-
E30Mark
- E30 Zone Team Member

- Posts: 8107
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Wimborne, Dorset
Halfords will not sell it, bung the bits in the car and pop into your local windscreen place, bung the guy a few quid and let him put the strips back in.
1 & 2 bed flats in Bournemouth areas, with parking
PM for details
PM for details
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Yep, they didnt do it.E30Mark wrote:Halfords will not sell it, bung the bits in the car and pop into your local windscreen place, bung the guy a few quid and let him put the strips back in.
Thats not a bad idea, so long as the glass stays in on the way down there. Will have to check out where the nearest place is.
Cheers
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
carlos_320i
- E30 Zone Newbie

- Posts: 203
- Joined: Thu Aug 04, 2005 11:00 pm
- Location: Kent
Give a mobile guy a call mate he will come out to you I phoned up some companey and they wanted £50 to come out and swap them out
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Cheers Carlos, but instead of fork out 50 i will be a cheap skate and give them another shot myself, otherwise i think their is a place on vestry estate.
By the way is that red e30 yours? I see a new one has appeared opposite your house. Also is your windscreen in the breaker any good? Im going to be re-Fitting my one with a big chip in it at the moment
Cheers
By the way is that red e30 yours? I see a new one has appeared opposite your house. Also is your windscreen in the breaker any good? Im going to be re-Fitting my one with a big chip in it at the moment
Cheers
Last edited by bmwe30mtech on Sun Feb 11, 2007 11:24 am, edited 1 time in total.
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
ian332isport
- E30 Zone Team Member

- Posts: 5380
- Joined: Wed Dec 22, 2004 11:00 pm
- Location: West Sussex
bmwe30mtech wrote:re-titting
If it aint broke - Modify it...
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Changedian332isport wrote:bmwe30mtech wrote:re-titting
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
carlos_320i
- E30 Zone Newbie

- Posts: 203
- Joined: Thu Aug 04, 2005 11:00 pm
- Location: Kent
Yes mate that is my red E30
And the windscreen has a scratch on it
where someone has let the wipers were out
And the windscreen has a scratch on it
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
Nice car the red one, i will have to take a proper look
I just finished everything with my roof lining (except the windscreen seals) , totally done, looks factory so im over the moon. Only took me 8 hours in total
. NEVER AGAIN.
Im ordering a tool for the screens off the internet as i type.
Cheers
I just finished everything with my roof lining (except the windscreen seals) , totally done, looks factory so im over the moon. Only took me 8 hours in total
Im ordering a tool for the screens off the internet as i type.
Cheers
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather


