Post
Wed Feb 07, 2007 6:57 pm
a frozen engine is definately not good, ithe water expands in the rad and waterways causing all sorts of damage... core plugs, split radiator, knackered waterpump, warped head ect etc but a fully frozen engine would be obvoius as the water pump would not turn and the fan belt would screech like hell!!!
if the car will not start this cannot be related to the issue of no hot air. first thing to check is the air flow meter especially the plug on the top as removing this would cause simlar probs to your symptoms. if not this then post again
if you do get it started then check for air and bleed air out of the system, you added a litre which is quite a lot of water!! as its a tourer its the later M20 engine so an 8mm bleed nut on top of the thermostat, turn heater to full hot and loosen the nut, leave car running till air no longer comes out of bleed, tighten keep running the car and open the nut again once fully hot with engine off, if air comes out keep nut open till water comes, then close nut start car and repeat till only water comes out.
