Opinions please

General E30 related discussions -
Please put technical questions in E30 Tech Help forum below

Moderator: martauto

User avatar
JonDubber
E30 Zone Newbie
E30 Zone Newbie
Posts: 95
Joined: Wed Nov 15, 2006 11:00 pm

Post Sun Feb 04, 2007 6:41 pm

Hey I could do with some Advice with my cabby. A few weeks ago I hit the sump and put an inch long gash in it. I didn't realise at the time so it seemed odd when it started running like shit. The oil light came on so I took it straight to my garage and put it on the ramps. Fixed the hole and filled it with 10w40 (it was all I had).

A week later it started making a bit of a knock, so I changed the oil for 15w40. It hasn't got any worse, but It still needs new bearings. Bearing in mind this is a 320i, would you rebuild the existing engine? Or buy another lump? It's started leaking oil from the rear crank oil seal and it killed my prop coupling, fitted a new one today and it already making the same symptoms as the old coupling (oil contamination?).

Really losing heart with this car...
maxfield
Old Skooler
Old Skooler
Posts: 15185
Joined: Sat Nov 26, 2005 11:00 pm
Location: Mansfield

Post Sun Feb 04, 2007 6:43 pm

you can put a 325 engine in for less than £300
Image
jbee
E30 Zone Newbie
E30 Zone Newbie
Posts: 223
Joined: Fri Jan 14, 2005 11:00 pm
Location: Hengoed, south wales

Post Sun Feb 04, 2007 6:49 pm

maxfield wrote:you can put a 325 engine in for less than £300
may as well
Image
bigkev
E30 Zone Regular
E30 Zone Regular
Posts: 612
Joined: Wed Jul 27, 2005 11:00 pm
Location: hibernating till summer

Post Sun Feb 04, 2007 6:51 pm

you may get away with some new shells which can be fitted in place depends on the condition of the crank, the rear crank seal is nowhere near the coupling so i dont know whats going on there as the rear seal is in the bell housing and the coupling is at the rear of the gearbox the worst that can happen is a slipping clutch , dont you mean a leaking gearbox output shaft ?
if you can do the work yourself all it will cost you is a sump gasket and some shells so worth a go i say, all depends if its a daily driver i suppose
good luck :)
Image
GingerTim
E30 Zone Newbie
E30 Zone Newbie
Posts: 240
Joined: Mon Dec 18, 2006 11:00 pm
Location: Oxfordshire

Post Sun Feb 04, 2007 7:20 pm

maxfield wrote:you can put a 325 engine in for less than £300
I'd go for that.
Image
User avatar
JonDubber
E30 Zone Newbie
E30 Zone Newbie
Posts: 95
Joined: Wed Nov 15, 2006 11:00 pm

Post Sun Feb 04, 2007 9:34 pm

bigkev wrote:you may get away with some new shells which can be fitted in place depends on the condition of the crank, the rear crank seal is nowhere near the coupling so i dont know whats going on there as the rear seal is in the bell housing and the coupling is at the rear of the gearbox the worst that can happen is a slipping clutch , dont you mean a leaking gearbox output shaft ?
if you can do the work yourself all it will cost you is a sump gasket and some shells so worth a go i say, all depends if its a daily driver i suppose
good luck :)
The oil is dropping from the hole at the front of the bell housing - being blown back whilst driving. You say it can be done in place, does the subframe have to be removed? Or does the engine have to be lifted slightly to get the sump off? I've priced the parts up in work - looking at around £25 for big ends and main bearings.

Where's the best place to get a Bentley manual for this?
Simon13
The longest resto in the world !
Posts: 22697
Joined: Mon Jan 10, 2005 11:00 pm
Location: Camberley, Surrey don't u know

Post Sun Feb 04, 2007 9:59 pm

if you do pull it out, why not go the 2.7 route etx bottom end with a 2.0 head.

You would be mad to rebuild a 2.0 imo. There's plenty of secondhand 2.0 lumps about too for little money
User avatar
JonDubber
E30 Zone Newbie
E30 Zone Newbie
Posts: 95
Joined: Wed Nov 15, 2006 11:00 pm

Post Sun Feb 04, 2007 10:06 pm

Simon13 wrote:if you do pull it out, why not go the 2.7 route etx bottom end with a 2.0 head.

You would be mad to rebuild a 2.0 imo. There's plenty of secondhand 2.0 lumps about too for little money
You make a good point, but unless the engine is still in the car, there's no way of telling whether its a good one or not. VW engines I can get good ones as I've been in the scene for years and made friends I can trust, but I haven't been in the BMW game for too long.