air lock problems

Need technical Q/A then you're in the right place

Moderator: martauto

marley_uk1
E30 Zone Newbie
E30 Zone Newbie
Posts: 115
Joined: Sun Jan 14, 2007 11:00 pm

Post Sat Feb 03, 2007 1:04 am

ive tried a few ways ive been told on the forum but still i cant get the air out so is their any1 with any other ideas. my car is a 325I 2 door, H reg bmw. Thanks
noney82
E30 Zone Camper
E30 Zone Camper
Posts: 1102
Joined: Thu Apr 27, 2006 11:00 pm
Location: manchester, stockport

Post Sat Feb 03, 2007 11:35 pm

i had the same problem with mine was ready to give up and burn it lol, what i did was run the car the car find the cold pipes, pull it off till hot water gets there, stick it back on. i had a hose pipe in the header tank some water level was constant, then once they all felt ok i pulled the return pipe off the top of the rad gave the car a little constant rev untill it started throwing hot water out, then i put it back on and all seem ok now. all i had to do was suck a bit off water out so i could put some anti freeze in. not saying this will work but it seems to off done for me. iv noticed that the bleed nipple on these cars are lower than the highest pipe lol
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Sat Feb 03, 2007 11:38 pm

it can take a lot of time to bleed properley..days, maybe weeks......
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
noney82
E30 Zone Camper
E30 Zone Camper
Posts: 1102
Joined: Thu Apr 27, 2006 11:00 pm
Location: manchester, stockport

Post Sat Feb 03, 2007 11:42 pm

took me 4 days to get it done, they are a pig to do
ian332isport
E30 Zone Team Member
E30 Zone Team Member
Posts: 5380
Joined: Wed Dec 22, 2004 11:00 pm
Location: West Sussex

Post Sat Feb 03, 2007 11:49 pm

Jacking the front of the car up as high as you can get it will help as well. Filling the system very slowly is also important.

Ian.
If it aint broke - Modify it...
liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Sat Feb 03, 2007 11:51 pm

park the car pointing uphill a tiny bit
turn heater valve on dash to hottest setting
if you like drive left wheel on to the kerb
fill resovoir almost to top and massage all the pipes
undo the thermo housing screw and massage what air you can out (i find it heops to have a friend working the top two hoses together and not releasing tilll you tighten screw again).
fill resovoir to very top
remove top hose from bulk head and let the water gush out a bit and refit quickly
again open thermohousing scvrew and massge some more air out if needed
close screw
start car
when you think the thermostat opens loosen screw massage pipes tighten screw
put resovovoir cap back on and let system pressurise/come up to temp
loosen screw let air come out .ie only water then tighten screw tighten screw

that should do the trick - your coolant should be around the correct level at this stage if not let car cool and top up.

it sounds over complicated but one you do it and get on with doing it that way not faffing about its a very quick and easy 10 min job

good luck
Image
liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Sat Feb 03, 2007 11:56 pm

i'm going to be shot now for saying its easy! :hide:
well i used to have problems with arlocks whenever i disturbed the cooling sytem but since i started doing this way its been fine.... filling slowly does help alot too as you dont force pockets of air down into the sytem.
Image
marley_uk1
E30 Zone Newbie
E30 Zone Newbie
Posts: 115
Joined: Sun Jan 14, 2007 11:00 pm

Post Sun Feb 04, 2007 3:01 am

thanks guys i will try your methods, and i have come close 2 setting the car alight, lol
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Feb 04, 2007 10:34 am

liam012 wrote:i'm going to be shot now for saying its easy! .
Follow liam012s advice and it is easy!
liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Sun Feb 04, 2007 12:13 pm

OT
brian- did your machine calibrate itself yet?
Image
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Feb 04, 2007 5:13 pm

liam012 wrote:OT
brian- did your machine calibrate itself yet?
Left it on for about six hours yesterday, and after about four the CO claimed to have calibrated up as well as the O2.
Tried it on a car exhaust, get O2 readings, but the CO never changed from 0.00.
Going to have to open up the gas bench and see if I can make any sense of it.
marley_uk1
E30 Zone Newbie
E30 Zone Newbie
Posts: 115
Joined: Sun Jan 14, 2007 11:00 pm

Post Mon Feb 05, 2007 10:46 pm

i think the head gasket might be gone so il have a compression check on the engine. one thing after another with these cars
noney82
E30 Zone Camper
E30 Zone Camper
Posts: 1102
Joined: Thu Apr 27, 2006 11:00 pm
Location: manchester, stockport

Post Mon Feb 05, 2007 11:09 pm

what makes you think that
dazleeds
old skool raver
old skool raver
Posts: 12883
Joined: Fri Apr 01, 2005 11:00 pm
Location: Empire Building @

Post Mon Feb 05, 2007 11:14 pm

marley_uk1 wrote:i think the head gasket might be gone so il have a compression check on the engine. one thing after another with these cars
read carefully and as long as ya flush system add that and kill the airlocks your sorted fella. a potion that actualy works :D

http://www.kalimex.co.uk/section.html?s ... 4.&pgid=17

nuff said :D
www.oldskoolfantasy.co.uk
in the shit,the one to blame,yeh its all my fault ;)
noney82
E30 Zone Camper
E30 Zone Camper
Posts: 1102
Joined: Thu Apr 27, 2006 11:00 pm
Location: manchester, stockport

Post Mon Feb 05, 2007 11:21 pm

iv used this stuff in the past its wicked stuff init