air lock problems
Moderator: martauto
-
marley_uk1
- E30 Zone Newbie

- Posts: 115
- Joined: Sun Jan 14, 2007 11:00 pm
ive tried a few ways ive been told on the forum but still i cant get the air out so is their any1 with any other ideas. my car is a 325I 2 door, H reg bmw. Thanks
-
noney82
- E30 Zone Camper

- Posts: 1102
- Joined: Thu Apr 27, 2006 11:00 pm
- Location: manchester, stockport
i had the same problem with mine was ready to give up and burn it lol, what i did was run the car the car find the cold pipes, pull it off till hot water gets there, stick it back on. i had a hose pipe in the header tank some water level was constant, then once they all felt ok i pulled the return pipe off the top of the rad gave the car a little constant rev untill it started throwing hot water out, then i put it back on and all seem ok now. all i had to do was suck a bit off water out so i could put some anti freeze in. not saying this will work but it seems to off done for me. iv noticed that the bleed nipple on these cars are lower than the highest pipe lol
-
kam-325i
- E30 Zone Team Member

- Posts: 4851
- Joined: Tue Sep 27, 2005 11:00 pm
- Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!
it can take a lot of time to bleed properley..days, maybe weeks......
Pete don't care about colour, He would shag a rainbow if he could find the end of it....


-
noney82
- E30 Zone Camper

- Posts: 1102
- Joined: Thu Apr 27, 2006 11:00 pm
- Location: manchester, stockport
took me 4 days to get it done, they are a pig to do
-
ian332isport
- E30 Zone Team Member

- Posts: 5380
- Joined: Wed Dec 22, 2004 11:00 pm
- Location: West Sussex
Jacking the front of the car up as high as you can get it will help as well. Filling the system very slowly is also important.
Ian.
Ian.
If it aint broke - Modify it...
-
liam012
- E30 Zone Camper

- Posts: 1424
- Joined: Sun Aug 28, 2005 11:00 pm
park the car pointing uphill a tiny bit
turn heater valve on dash to hottest setting
if you like drive left wheel on to the kerb
fill resovoir almost to top and massage all the pipes
undo the thermo housing screw and massage what air you can out (i find it heops to have a friend working the top two hoses together and not releasing tilll you tighten screw again).
fill resovoir to very top
remove top hose from bulk head and let the water gush out a bit and refit quickly
again open thermohousing scvrew and massge some more air out if needed
close screw
start car
when you think the thermostat opens loosen screw massage pipes tighten screw
put resovovoir cap back on and let system pressurise/come up to temp
loosen screw let air come out .ie only water then tighten screw tighten screw
that should do the trick - your coolant should be around the correct level at this stage if not let car cool and top up.
it sounds over complicated but one you do it and get on with doing it that way not faffing about its a very quick and easy 10 min job
good luck
turn heater valve on dash to hottest setting
if you like drive left wheel on to the kerb
fill resovoir almost to top and massage all the pipes
undo the thermo housing screw and massage what air you can out (i find it heops to have a friend working the top two hoses together and not releasing tilll you tighten screw again).
fill resovoir to very top
remove top hose from bulk head and let the water gush out a bit and refit quickly
again open thermohousing scvrew and massge some more air out if needed
close screw
start car
when you think the thermostat opens loosen screw massage pipes tighten screw
put resovovoir cap back on and let system pressurise/come up to temp
loosen screw let air come out .ie only water then tighten screw tighten screw
that should do the trick - your coolant should be around the correct level at this stage if not let car cool and top up.
it sounds over complicated but one you do it and get on with doing it that way not faffing about its a very quick and easy 10 min job
good luck

-
liam012
- E30 Zone Camper

- Posts: 1424
- Joined: Sun Aug 28, 2005 11:00 pm
i'm going to be shot now for saying its easy! :hide:
well i used to have problems with arlocks whenever i disturbed the cooling sytem but since i started doing this way its been fine.... filling slowly does help alot too as you dont force pockets of air down into the sytem.
well i used to have problems with arlocks whenever i disturbed the cooling sytem but since i started doing this way its been fine.... filling slowly does help alot too as you dont force pockets of air down into the sytem.

-
marley_uk1
- E30 Zone Newbie

- Posts: 115
- Joined: Sun Jan 14, 2007 11:00 pm
thanks guys i will try your methods, and i have come close 2 setting the car alight, lol
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Follow liam012s advice and it is easy!liam012 wrote:i'm going to be shot now for saying its easy! .
-
liam012
- E30 Zone Camper

- Posts: 1424
- Joined: Sun Aug 28, 2005 11:00 pm
OT
brian- did your machine calibrate itself yet?
brian- did your machine calibrate itself yet?

-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Left it on for about six hours yesterday, and after about four the CO claimed to have calibrated up as well as the O2.liam012 wrote:OT
brian- did your machine calibrate itself yet?
Tried it on a car exhaust, get O2 readings, but the CO never changed from 0.00.
Going to have to open up the gas bench and see if I can make any sense of it.
-
marley_uk1
- E30 Zone Newbie

- Posts: 115
- Joined: Sun Jan 14, 2007 11:00 pm
i think the head gasket might be gone so il have a compression check on the engine. one thing after another with these cars
-
noney82
- E30 Zone Camper

- Posts: 1102
- Joined: Thu Apr 27, 2006 11:00 pm
- Location: manchester, stockport
what makes you think that
-
dazleeds
- old skool raver

- Posts: 12883
- Joined: Fri Apr 01, 2005 11:00 pm
- Location: Empire Building @
read carefully and as long as ya flush system add that and kill the airlocks your sorted fella. a potion that actualy worksmarley_uk1 wrote:i think the head gasket might be gone so il have a compression check on the engine. one thing after another with these cars
http://www.kalimex.co.uk/section.html?s ... 4.&pgid=17
nuff said
www.oldskoolfantasy.co.uk
in the shit,the one to blame,yeh its all my fault ;)
in the shit,the one to blame,yeh its all my fault ;)
-
noney82
- E30 Zone Camper

- Posts: 1102
- Joined: Thu Apr 27, 2006 11:00 pm
- Location: manchester, stockport
iv used this stuff in the past its wicked stuff init
