Anyone out there with any ideas as to how i can get the bitch off
cheers
Moderator: martauto














That way has worked every time for me especialy with fecked locking wheel nuts!noney82 wrote:i had this problem once it was a 17mm rouunded off, i got a 16mm socket and hit it on the nut with hammer then got a big breaker bar and slowly went for it, worked a treat but couldnt use 16mm again but was worth it.


Personally, I like the OEM wheelbrace; a high quality bit of kit, which - surprise surprise - fits the bolts perfectlyHow do you boys manage to 'round off' wheel bolts?
You must be using some really cheap sh!t pound shop sockets! The only type of socket you should be using is a deep hexagon, the depth to keep the bar away from the wheel rim and the hexagon to hold the bolt properly.

Their the ones dude ate thru the stud with ease! must have went thru 20 odd HSS bits first all New one's mind! Than god my mate had the key's to a machining shop that day! otherwise i think id still be there LolDanThe wrote:How do you boys manage to 'round off' wheel bolts?
You must be using some really cheap sh!t pound shop sockets! The only type of socket you should be using is a deep hexagon, the depth to keep the bar away from the wheel rim and the hexagon to hold the bolt properly.
I wouldnt put a welder near my rims, alloy doesnt take to kindly to molten steel.
Diamond tipped? Wilco special by any chance?Carbide is the best for the job, but standard HSS bits (of half decent quality) will do if sharpened properly.






