Looong brake pedal travel..

Need technical Q/A then you're in the right place

Moderator: martauto

pictonroad
E30 Zone Newbie
E30 Zone Newbie
Posts: 226
Joined: Mon Dec 04, 2006 11:00 pm
Location: Worthing. Innit.

Post Mon Jan 22, 2007 10:29 am

I've only owned it a day and the first thing to be addressed HAS to be this... 8O It's unsettling me..

The brakes only bite right at the bottom of the pedal travel. I checked the brake fluid and that's at the right level, I'll do the pads next weekend, shouldn't the car compensate for worn pads anyway though?

Any ideas, it's an 89 car, with rear drums.

Cheers

James
Demlotcrew
E30 Zone Team Member
E30 Zone Team Member
Posts: 13329
Joined: Mon Dec 20, 2004 11:00 pm
Location: East Anglia

Post Mon Jan 22, 2007 11:23 am

Could be;

Old brake fluid
Cracking rubber brake lines
Worn master cylinder
No brake assistance from booster

Andrew
DaveD
E30Zone Wiki Specialist
Posts: 5129
Joined: Tue Jan 11, 2005 11:00 pm
Location: Sheffield

Post Mon Jan 22, 2007 1:57 pm

if you need an upgrade you can replace the master cylinder with one from a 7 series (i think its a 25mm) and get more fuid through...do a search on it as i am no expert
carpmart
E30 Zone Newbie
E30 Zone Newbie
Posts: 97
Joined: Thu Sep 21, 2006 11:00 pm
Location: Bedfordshire J12 M1

Post Mon Jan 22, 2007 11:06 pm

First off is a visual inspection to check for leaks, worn pipes etc! Once you have completed that, proceed with a fluid change!

What you describe is a common issue on older cars (overlooked by owners) and the brake fluid could be VERY old by now! Old fluid absorbs a lot of water which leads to spongy brakes. First job is to renew the fluid. Easy job for two people and you really need to follow a web guide or get a Haynes manual to tell you how! I alway used to syringe as much of the old fluid out of the reservoir before I start as it then requires less effort to clear the old stuff through the bleed nipples! Make sure that you dont let the reservoir run dry and bleed the brakes in the order of the manual. Also, try to get the newest bottle of brake fluid from the back of the shelf as opposed to the dusty old bottle! I know this is obvious but never shake it and make sure you leave it to stand for a day after transporting it back from the motor factors! This really is not a difficult job but always be very careful with brakes as they are fundemental to safety. Remember to then re-bleed the brakes a minimum of 12 hours after completing the change to make sure you have not inadvertantly trapped any air!

A nice tool, and one worth the investment (in my opinion) is to get yourself one of the pressurised brake bleeder kits which connects to a compressor. This leads to very easy fluid changes and bleeding.

Above, in my experience, will solve the issue for a lot of cars but if not, you are back to Andrews (Demlotcrew) list and a more extensive investigation.

Good luck! :thumb:
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Tue Jan 23, 2007 9:00 am

My vote is for non working rear brake adjusters.
Hand brake cables have possible been over tightened to bodge the handbrake back into working order, so slacken them off, sort the adjusters, possibly fit new shoes, and set the whole lot up from scratch.
User avatar
eltel
E30 Zone Regular
E30 Zone Regular
Posts: 654
Joined: Wed Nov 09, 2005 11:00 pm
Location: mid wales

Post Tue Jan 23, 2007 12:27 pm

whats the " brake booster" mentioned by demlotcrew???
Only in the good lord we trust.. In everything else we check!!


1988 325i Tourer, Lowered, Deep Dish Alloys, Obc, Cruise Control, Heated Leather Sport Seats....
Chris-W
E30 Zone Team Member
E30 Zone Team Member
Posts: 7219
Joined: Tue May 24, 2005 11:00 pm
Location: South Cheshire

Post Tue Jan 23, 2007 7:16 pm

Servo.
Image