I have a stainless system (with lifetime guarantee), but the supplier is on the south coast and I'm not.
So I am toying with replacing the down pipes with standard items while I post off my chimney for repair.
My manifold is a two-pipe one-flange (rectangular) unit. It looks different to those listed for my car 320i cabby 1990, which seem to have twin triangular flanges. I assume they are not inter-changeable.
I also assume 320i and 325i items are the same.
Do I assume correctly?
I am tempted to buy a new stock full system and sell the stainless chimney.
this is my egg horse fannymould:

I take it that it is standard. Do I assume correctly again?




