snapped down pipe

Need technical Q/A then you're in the right place

Moderator: martauto

johnna
E30Zone Irregular
Posts: 1715
Joined: Sat Sep 17, 2005 11:00 pm
Location: In the hole

Post Sun Jan 07, 2007 8:47 pm

bugger. It looks to be sheared.
I have a stainless system (with lifetime guarantee), but the supplier is on the south coast and I'm not.

So I am toying with replacing the down pipes with standard items while I post off my chimney for repair.
My manifold is a two-pipe one-flange (rectangular) unit. It looks different to those listed for my car 320i cabby 1990, which seem to have twin triangular flanges. I assume they are not inter-changeable.
I also assume 320i and 325i items are the same.

Do I assume correctly?

I am tempted to buy a new stock full system and sell the stainless chimney.

this is my egg horse fannymould:

Image

I take it that it is standard. Do I assume correctly again?
Be a man for once in your life and sh!t in that boot!- Wilfred.
Templ8e30
E30 Zone Addict
E30 Zone Addict
Posts: 2801
Joined: Mon Jan 10, 2005 11:00 pm
Location: Ashton-under-Lyne, Lancashire

Post Sun Jan 07, 2007 9:05 pm

Yup standard single flange facelift fannymold, the only question is is the larger flange or small flange ?

Some 320i's use the 325i manifold, I found this when I got a 320i downpipe gasket for my 320i and it was too small. The 325i gasket was a perfect fit :mad:

Cheers,

Iain T
Image
2007 Mazda 6 2.0 estate
Political Correctness - A concept based on the idea that its possible to pick up a turd by the clean end !
johnna
E30Zone Irregular
Posts: 1715
Joined: Sat Sep 17, 2005 11:00 pm
Location: In the hole

Post Sun Jan 07, 2007 9:14 pm

oh bugger. Dunno which...

Anyone got dimensions of the two facelift flanges?
Be a man for once in your life and sh!t in that boot!- Wilfred.
handpaper
E30 Zone Regular
E30 Zone Regular
Posts: 883
Joined: Sun Apr 16, 2006 11:00 pm
Location: Newport, South Wales

Post Mon Jan 08, 2007 11:07 am

I don't know about the bigger one, but here's the the one that's too small for my manifold:
Image
johnna
E30Zone Irregular
Posts: 1715
Joined: Sat Sep 17, 2005 11:00 pm
Location: In the hole

Post Mon Jan 08, 2007 11:13 pm

I shall measure mine and report back...

wor lass claims it is small...
Be a man for once in your life and sh!t in that boot!- Wilfred.
johnna
E30Zone Irregular
Posts: 1715
Joined: Sat Sep 17, 2005 11:00 pm
Location: In the hole

Post Mon Jan 08, 2007 11:41 pm

The standard 320i item fitted mine, but:
130 by 55mm centre to centre on the old manifold...

Hmmm :?
Be a man for once in your life and sh!t in that boot!- Wilfred.