thinks i got an airlock:(
Moderator: martauto
-
blacksoul
- E30 Zone Newbie

- Posts: 168
- Joined: Sun Jul 03, 2005 11:00 pm
- Location: cwmbran south wales
hi guys few days ago my clutch felt funny. went all flopy. so got home and checked the fluid it was empty
anyway got some fluid and topped her up. but i think there must be air stuck under the fluid now cos i cant change gear at all. so my question is even though i might sound a bit dull, how do i go about bleeding the air out. any advice would be fantastic. its a 87 325i convertible. thanx b.
-
Gortour
- E30 Zone Team Member

- Posts: 9025
- Joined: Sat Sep 23, 2006 11:00 pm
- Location: Poole, Dorset
Easiest way is with a Gunsons Easi-Bleed. (only about £15 - £20)
All you need is a bottle with fluid connected to the clutch master cylinder and a spare tyre, then undo the bleed nipple on the slave cylinder, and do the bleed nipple up when it pees pure fluid. Otherwise its a two man job, one to pump the clutch, one under the car on the bleed nipple, and bleed it manually as you would the brakes.
All you need is a bottle with fluid connected to the clutch master cylinder and a spare tyre, then undo the bleed nipple on the slave cylinder, and do the bleed nipple up when it pees pure fluid. Otherwise its a two man job, one to pump the clutch, one under the car on the bleed nipple, and bleed it manually as you would the brakes.
Currently slumming it in an E46 Touring
-
gooner1
- Out humping Reindeer
- Posts: 13280
- Joined: Fri Apr 14, 2006 11:00 pm
- Location: Northampton.For my sins.
Might need to let some pressure out of your spare tyre first though, done my brakes this way and got fluid
all over the place.Lucky i didnt blow seals on the brake reservoir thingy.Think it needs to be about 20 psi if irc.
Might be different for clutches though.
all over the place.Lucky i didnt blow seals on the brake reservoir thingy.Think it needs to be about 20 psi if irc.
Might be different for clutches though.

-
Gortour
- E30 Zone Team Member

- Posts: 9025
- Joined: Sat Sep 23, 2006 11:00 pm
- Location: Poole, Dorset
All in the instructions for the easi-bleed. Think it's actually 15psi...
Currently slumming it in an E46 Touring
-
gooner1
- Out humping Reindeer
- Posts: 13280
- Joined: Fri Apr 14, 2006 11:00 pm
- Location: Northampton.For my sins.
Oooops did i forget to say i didnt read the destructions properleygortour wrote:All in the instructions for the easi-bleed. Think it's actually 15psi...

-
Gortour
- E30 Zone Team Member

- Posts: 9025
- Joined: Sat Sep 23, 2006 11:00 pm
- Location: Poole, Dorset
... When all else fails ...gooner1 wrote: Oooops did i forget to say i didnt read the destructions properley
very fair comment though, should really have mentioned the tyre pressure in my first post. Sorry guys.
Currently slumming it in an E46 Touring
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
There's another way that's supposed to be good for awkward clutch hydraulics.
Open the front left caliper bleed nipple and flush the dirt out, connect a piece of plastic tube to the nipple and feed it with fluid from the brakes until it's full, push it on the clutch nipple, open the clutch nipple, and then proceed to "bleed" the brake in the normal manner, until you've pushed all the air back up to the clutch resevoir.
Open the front left caliper bleed nipple and flush the dirt out, connect a piece of plastic tube to the nipple and feed it with fluid from the brakes until it's full, push it on the clutch nipple, open the clutch nipple, and then proceed to "bleed" the brake in the normal manner, until you've pushed all the air back up to the clutch resevoir.
-
old_skool
- E30 Zone Team Member

- Posts: 3405
- Joined: Fri Sep 01, 2006 11:00 pm
- Location: Glossersure
Now that is clever. No reason I can see why that won't work.There's another way that's supposed to be good for awkward clutch hydraulics.
Open the front left caliper bleed nipple and flush the dirt out, connect a piece of plastic tube to the nipple and feed it with fluid from the brakes until it's full, push it on the clutch nipple, open the clutch nipple, and then proceed to "bleed" the brake in the normal manner, until you've pushed all the air back up to the clutch resevoir.
-
Gortour
- E30 Zone Team Member

- Posts: 9025
- Joined: Sat Sep 23, 2006 11:00 pm
- Location: Poole, Dorset
Very clever. I'd never have thought of using the brakes to bleed the clutch...
Brilliant as always Brian.
Brilliant as always Brian.
Currently slumming it in an E46 Touring
