Kerbing repairs
Moderator: martauto
-
nolc
- E30 Zone Newbie

- Posts: 24
- Joined: Sat Nov 25, 2006 11:00 pm
sdfghhjkllllllllllllllllllllllllllllll
Last edited by nolc on Sat Feb 10, 2007 10:34 am, edited 1 time in total.
-
thebigone
- E30 Zone Regular

- Posts: 294
- Joined: Sat Jul 29, 2006 11:00 pm
- Location: Newhaven (south coast)
I have used in the past, a metal filler that you can get from a hobby shop, it is used on railway track connections a bit like liqued metal you are able to mould it then sand it down hth
-
325bhpbruiser
- E30 Zone Newbie

- Posts: 118
- Joined: Sat Dec 02, 2006 11:00 pm
- Location: north west
try quick steel mate, under a tenner a tube, dries rock hard you can drill and screw into it and also sandable.
only tip i can gan give i mix the to dough's as best as you can before it starts to set.
only tip i can gan give i mix the to dough's as best as you can before it starts to set.

-
mattresstester
- E30 Zone Newbie

- Posts: 16
- Joined: Sun Dec 03, 2006 11:00 pm
Quick question: once it's set, how does it look? Matt? Shiny?325bhpbruiser wrote:try quick steel mate, under a tenner a tube, dries rock hard you can drill and screw into it and also sandable.
only tip i can gan give i mix the to dough's as best as you can before it starts to set.
Cheers.
-
iil325i
- E30 Zone Regular

- Posts: 589
- Joined: Fri May 06, 2005 11:00 pm
- Location: cambs
if there not to bad you can sand them ou twith 240 grit


-
325bhpbruiser
- E30 Zone Newbie

- Posts: 118
- Joined: Sat Dec 02, 2006 11:00 pm
- Location: north west
half and half really mattrestester.

