I've only ever had to throw away one motor that was beyond repair, and that was because the steel motor casing had rusted right away.
Yours looks non too clever in the picture, but as long as there's still enough case to locate the magnets, then it should go again.
First thing to remove is the output shaft/pinion gear and the rack that goes from it to the plastic gear behind the plate. This is the shaft that seizes and causes the wipers to quit, so it might take some time and effort to remove it.
After these are removed, the metal plate unclips and the rest is obvious.
hi brian is it a case of prying off the spindle at the front with plenty of wd40, elbow grease and mole grips. i have taken all the nuts and bolts off the spindle.
Spindle comes out backwards through the motor, and yes, it's a matter of getting a little movement and then working in WD40 untill it all comes free.
Put a wiper arm back on to turn the shaft, but don't turn hard enough to break the arm or strip the splines. If you do have to resort to grips as well, you'll have to clean up the damage on the shaft before it'll go back through the bush.
Hi casing on motor has hole in it so that one is binned,taken of n/s one,motor casing ok but having trouble removing spindle.Looks like I will be visiting the wanted section.thanks for the help.
noney82 wrote:what was the point behind these wipers
To keep the headlamps clean!
They are actually very effective, especially at this time of year with the build up of salt on the car.
After a drive in the mildy wet current conditions, try parking up against a wall, clean one headlamp and then compare light outputs on the wall between the clean one and the dirty lamp, the results will probably shock you.