engine cleaning
Moderator: martauto
-
gooner1
- Out humping Reindeer
- Posts: 13280
- Joined: Fri Apr 14, 2006 11:00 pm
- Location: Northampton.For my sins.
Have an engine for my m3o conversion that i want to clean up while its still out of car.Is it just a case of covering all the electrical parts then giving it a good hose down followed by a good scrub with some kind of chemical cleaner and hose down again.Want to do it while i have a couple of days off but bit worriied by the fact that its not in car and cant be started to dry it out.
-
Andy335Touring
- Married to the E30 Zone

- Posts: 7144
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Long Eaton,Nottingham
Should be able to unplug the loom then clean it like you say, try to make sure you don't get water into the inlet manifold or up the exhaust manifold so you don't get any water inside the engine.
Are you doing any other prep work like new oil seals/service parts/etc ?
A job that's a lot easier with the engine out is to flush the block out, theres a drain plug hiding on the exhaust side at the bottom towards the back, 19mm hex i think it is.
Are you doing any other prep work like new oil seals/service parts/etc ?
A job that's a lot easier with the engine out is to flush the block out, theres a drain plug hiding on the exhaust side at the bottom towards the back, 19mm hex i think it is.
-
Andy335Touring
- Married to the E30 Zone

- Posts: 7144
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Long Eaton,Nottingham
BTW if your up my way over christmas feel free to pop in for a chat
-
mybmw6
- E30 Zone Newbie

- Posts: 153
- Joined: Tue Sep 20, 2005 11:00 pm
Andy, this block flush. Are you talking about flushing the coolant passages around the engine?Andy335Touring wrote:A job that's a lot easier with the engine out is to flush the block out, theres a drain plug hiding on the exhaust side at the bottom towards the back, 19mm hex i think it is.
Cheers Matt
-
Andy335Touring
- Married to the E30 Zone

- Posts: 7144
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Long Eaton,Nottingham
yes, whip the plug out and flush it through with a hose pipe from the 'stat housing or water pumpmybmw6 wrote:Andy, this block flush. Are you talking about flushing the coolant passages around the engine?Andy335Touring wrote:A job that's a lot easier with the engine out is to flush the block out, theres a drain plug hiding on the exhaust side at the bottom towards the back, 19mm hex i think it is.
Cheers Matt
-
mybmw6
- E30 Zone Newbie

- Posts: 153
- Joined: Tue Sep 20, 2005 11:00 pm
Thanks Andy, just thought I'd check incase there was something I didn't know about
While I'm here, Merry Christmas to everyone!
While I'm here, Merry Christmas to everyone!
