engine cleaning

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
gooner1
Out humping Reindeer
Posts: 13280
Joined: Fri Apr 14, 2006 11:00 pm
Location: Northampton.For my sins.

Post Fri Dec 22, 2006 12:07 pm

Have an engine for my m3o conversion that i want to clean up while its still out of car.Is it just a case of covering all the electrical parts then giving it a good hose down followed by a good scrub with some kind of chemical cleaner and hose down again.Want to do it while i have a couple of days off but bit worriied by the fact that its not in car and cant be started to dry it out.
Andy335Touring
Married to the E30 Zone
Married to the E30 Zone
Posts: 7144
Joined: Sun Jan 09, 2005 11:00 pm
Location: Long Eaton,Nottingham

Post Fri Dec 22, 2006 1:27 pm

Should be able to unplug the loom then clean it like you say, try to make sure you don't get water into the inlet manifold or up the exhaust manifold so you don't get any water inside the engine.

Are you doing any other prep work like new oil seals/service parts/etc ?

A job that's a lot easier with the engine out is to flush the block out, theres a drain plug hiding on the exhaust side at the bottom towards the back, 19mm hex i think it is.
Andy335Touring
Married to the E30 Zone
Married to the E30 Zone
Posts: 7144
Joined: Sun Jan 09, 2005 11:00 pm
Location: Long Eaton,Nottingham

Post Fri Dec 22, 2006 1:28 pm

BTW if your up my way over christmas feel free to pop in for a chat
mybmw6
E30 Zone Newbie
E30 Zone Newbie
Posts: 153
Joined: Tue Sep 20, 2005 11:00 pm

Post Fri Dec 22, 2006 2:18 pm

Andy335Touring wrote:A job that's a lot easier with the engine out is to flush the block out, theres a drain plug hiding on the exhaust side at the bottom towards the back, 19mm hex i think it is.
Andy, this block flush. Are you talking about flushing the coolant passages around the engine?
Cheers Matt
Andy335Touring
Married to the E30 Zone
Married to the E30 Zone
Posts: 7144
Joined: Sun Jan 09, 2005 11:00 pm
Location: Long Eaton,Nottingham

Post Fri Dec 22, 2006 2:25 pm

mybmw6 wrote:
Andy335Touring wrote:A job that's a lot easier with the engine out is to flush the block out, theres a drain plug hiding on the exhaust side at the bottom towards the back, 19mm hex i think it is.
Andy, this block flush. Are you talking about flushing the coolant passages around the engine?
Cheers Matt
yes, whip the plug out and flush it through with a hose pipe from the 'stat housing or water pump
mybmw6
E30 Zone Newbie
E30 Zone Newbie
Posts: 153
Joined: Tue Sep 20, 2005 11:00 pm

Post Sat Dec 23, 2006 1:58 am

Thanks Andy, just thought I'd check incase there was something I didn't know about :mad:

While I'm here, Merry Christmas to everyone!