Cheers
no sound stereo
Moderator: martauto
-
spanner
- E30 Zone Newbie

- Posts: 13
- Joined: Wed Jun 15, 2005 11:00 pm
Well just fitted a new system,speakers appeared to be blown as it had bad distortion.Good excuse for new speakers,after fitting no difference.It had alot of dodgy wiring so I took it back to basics,NO sound at all now,you can hear it in background if its flat out but thats it .To much volume and the speakers completely cut out.Never had any problems fitting units before so Im of the opinion there must be an amp fitted as standard somewhere.Its on a m3 1991 any ideas?
Cheers

Cheers
-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
-
toby
- E30 Zone Addict

- Posts: 3609
- Joined: Thu Aug 11, 2005 11:00 pm
- Location: Kent
Are the speakers wired up wrong way round perhaps fella?

-
spanner
- E30 Zone Newbie

- Posts: 13
- Joined: Wed Jun 15, 2005 11:00 pm
No wired right but Im using original speaker wiring.All wiring is the bmw loom connected to sony block.
-
noney82
- E30 Zone Camper

- Posts: 1102
- Joined: Thu Apr 27, 2006 11:00 pm
- Location: manchester, stockport
i had this same problem, it turned out that the orig bmw wiring is not much cop, i pulled it out it it seems that the loop lives over to the speakers iv still got the orig harness, the best way to over come the problem is re-wire the speakers yourself, easy enough to do. i took passanger front seat out that where the side the wires run to the back.
-
toby
- E30 Zone Addict

- Posts: 3609
- Joined: Thu Aug 11, 2005 11:00 pm
- Location: Kent
Ok is there isn't some silly switch or fader type misadjustment (you may have set by accident) on the headunit somewhere that is throwing things out?
If the wiring is the absolute original factory stuff there should be no chance of error.
I would make it simple and connect up the system using the old speakers just sitting on the floor and just normal wires to elimiante the chance of wiring fault in the old wires.
If the wiring is the absolute original factory stuff there should be no chance of error.
I would make it simple and connect up the system using the old speakers just sitting on the floor and just normal wires to elimiante the chance of wiring fault in the old wires.

-
zaust
- Zone day release
- Posts: 13007
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Somewhere in Hertfordshire , or press Ctrl + W
-
kam325itouring
- E30 Zone Regular

- Posts: 692
- Joined: Sun Apr 02, 2006 11:00 pm
- Location: london
have you got the original fader still in the car???? if so Just rewire the speakers its easier!!
-
spanner
- E30 Zone Newbie

- Posts: 13
- Joined: Wed Jun 15, 2005 11:00 pm
Thanks everybody
bought new cables today just going to rewire the whole thing.seems to have been the route most recommend.Keep me out of trouble if nothing else
bought new cables today just going to rewire the whole thing.seems to have been the route most recommend.Keep me out of trouble if nothing else
-
noney82
- E30 Zone Camper

- Posts: 1102
- Joined: Thu Apr 27, 2006 11:00 pm
- Location: manchester, stockport
you should be ok with that mate like i said i had the same problem let us know the outcome
-
spanner
- E30 Zone Newbie

- Posts: 13
- Joined: Wed Jun 15, 2005 11:00 pm
Sorted! rewired the thing from start to finish worked perfect from the word go.The standard wiring has to be checked out My yellow which was live feed turned out to be putting out 2 volts when I rewired the speakers,it was 12 before.Dont know why,dont care took new feed and it is fine. If I was doing it again I would just do the full rewire easy done and I would have had it finished in half the time 
-
toby
- E30 Zone Addict

- Posts: 3609
- Joined: Thu Aug 11, 2005 11:00 pm
- Location: Kent
Good for you and your Sony 

-
noney82
- E30 Zone Camper

- Posts: 1102
- Joined: Thu Apr 27, 2006 11:00 pm
- Location: manchester, stockport
good to hear spanner, i never trust old wiring


