what clutch fluid do i use?

Need technical Q/A then you're in the right place

Moderator: martauto

bennyboy
E30 Zone Newbie
E30 Zone Newbie
Posts: 218
Joined: Mon Jan 10, 2005 11:00 pm
Location: West Sussex

Post Wed Dec 06, 2006 1:07 pm

i have had two slave cylinders go in the last few hundred miles. i have used Halfrauds brake/clutch fluid both times and i think this is what has caused them both to leak.
Image
16V IS engine!!!
User avatar
orangecurry
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Apr 11, 2005 11:00 pm
Location: West Sussex

Post Wed Dec 06, 2006 1:21 pm

doubtful - Halfords will just be buying stuff which is just at British-standard quality, so it should be up to the job.

Were the slaves new?
bennyboy
E30 Zone Newbie
E30 Zone Newbie
Posts: 218
Joined: Mon Jan 10, 2005 11:00 pm
Location: West Sussex

Post Wed Dec 06, 2006 4:21 pm

no but they looked pretty good on inspection. just seems a bit strange that they should both fail in such a short time (couple of weeks)! i have just bought a new one and dont want to go fcuking this one up! the last one failed last night when i was 160 miles from home and had to wait 6 hours for AA.

Both the last two went when i was using DOT 4 fluid. should i be using mineral oil?
Image
16V IS engine!!!
jcjdavis1
E30 Zone Camper
E30 Zone Camper
Posts: 1128
Joined: Thu Apr 13, 2006 11:00 pm
Location: Paisley Scotland

Post Wed Dec 06, 2006 6:15 pm

Hi secondhand can be more expensive than buying new as I found to my cost.I had two fuel pumps go before I bought new.
Image
DRIFTBOY
E30 Zone Addict
E30 Zone Addict
Posts: 3131
Joined: Mon May 22, 2006 11:00 pm
Location: Kent

Post Wed Dec 06, 2006 6:22 pm

Any dot3 or dot4 brake fluid is ok for clutch fluid.

From what I've read in the past it might be wise to also fit a new clutch master cylinder.
Having a new slave will likely put more stress on the aold master cylinder and they often fail shortly after fitting a new slave - and vice versa.
Jeremy Clarkson wrote:...but it drives the front wheels. Theee wrooong wheels!
da4x4turbo wrote:I raced a vivaro on the motorway once in a 318is.... and lost!!!
fuzzy
He who sleeps with "Gingers"
Posts: 14351
Joined: Sat Jun 04, 2005 11:00 pm
Location: melbourne Australia

Post Wed Dec 06, 2006 6:32 pm

i think it would be down to pure bad luck to have had 2 cylinders fail rather than blaming the halfords clutch fluid.if i remember correct slave cylinders are under £30 new from ECP so it isnt worth buying second hand,but hindsight is a wonderful thing :wink:
jmc330i
Engaged to the E30 Zone
Engaged to the E30 Zone
Posts: 6621
Joined: Mon Jan 10, 2005 11:00 pm
Location: Somerset

Post Wed Dec 06, 2006 6:39 pm

My 325i has been running on Halfrauds clutch fluid for the last 6 months and my Sport had the Halfrauds stuff for 2-3 years without problems.
James
'91 325i Sport
'93 318i touring 16v
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Wed Dec 06, 2006 11:29 pm

bennyboy wrote: the last one failed last night when i was 160 miles from home and had to wait 6 hours for AA.
Few driving lessons in order I think! No problem in driving a car with a permanently engaged clutch, although it helps to avoid stop/start traffic.
If you changed the slave without changing the master, that is probably the problem. Debris from the master is getting into the slave and damaging it.
bennyboy
E30 Zone Newbie
E30 Zone Newbie
Posts: 218
Joined: Mon Jan 10, 2005 11:00 pm
Location: West Sussex

Post Thu Dec 07, 2006 12:15 pm

Thanks everyone. i rang the AA at 5 in the evening coz it was rush hour and thought that i would be on my way home in the next 60-90 mins. looking back i wish i had waited till 8-9 o'clock and driven without the clutch. but never mind.
its interesting you should comment on the master though. i changed that a few weeks before the first slave went. as you say, the old one probably broke up inside.
Any ideas on how to flush the system out before i put the new slave on?
Image
16V IS engine!!!