A company in the States called BMP Design used to sell a kit for about £1500 but dont sell them anymore
Just wondered whether anybody had tried and got any useful gains? Also want them cos they look good, but £1500 for looks is alot.
Tee
Moderator: martauto









Havent got a clue yet. Is it the bigger the better or is there a limit?Turbo-Brown wrote:Aah that reminds me!
What size TBs are you gonna make tee?


What are "runners" mate? the tubes from the plenum chamber to the throttle bodies?Turbo-Brown wrote:Yeah, it's definately use the right size or regret it.
The ports are about 36mm on the 2.5 M20 so using 38mm should work out nicely.
I did 40mm/cyl for mine and it does lack a little in low end torque, although that could be improved if I switched to smaller diameter runners (currently 48mm).
Jenvey's site says that 40mm/cyl is enough for 50bhp/cyl so unless you reasistically expect to get more than 300bhp N/A from your engine I'd treat that as the upper limit.

What you can do is buy a triple carb inlet manifold from Mangoletsi and buy three old Weber 40DCOE's. The Webers can be gutted of all the jets, sleeved and fitted with an injector per choke. It's been done on all kinds of engines so why not a BMW? You'd need Megasquirt to make it all work but you'd need a pretty hairy cam to get it all running okay.ajm-e30 wrote:i no someone who has triple webber 45's on his 325i,




Yeh there the ones!Andy335Touring wrote:link doesn't work, i think they sold the Dhiblas(Sp?) TB's the same as Scotts ?

Yeah, try this placetee wrote:
Cant seem to insert image? ah just realised I have uploaded the pic to a private forum. where can I publicaly post pics up??

I guess you'd use a standard BMW cam then!Turbo-Brown wrote:
Why would you need a hairy cam to make it run too?

Whos car is this? tried to search "Dhiblas" and got nothing. Anyone know the name of this fit and if it is still available anywhere?Andy335Touring wrote:link doesn't work, i think they sold the Dhiblas(Sp?) TB's the same as Scotts ?





remember, that while they look similar, they work completely differently.Andyboy wrote:True, but stick a pair of 40DCOE's on a standard 2 litre Pinto - sod all torque at the bottom end unless you fitted tiny chokes and not much at the top end either because the valves don't open deep or long enough to get the benefit. You could fit a cam from a Rolls Royce 20/25 and it would idle and run, but........
I'm going back years and years now to a Mark 2 Escort Mexico I had and it was just awful on 40DCOE's and savage on fuel. It had to be choked and jetted down to the point where really, it only gave 15 bhp more than a standard car with the 32/36 Weber and it was horrible to drive. With a Burton cam (can't remember the profile) it went like a rocket and I fitted an Aldon (?) rev limiter because it just revved to 6000 and beyond. I'm not suggesting some 302 degree race cam, but a nice spiky 285 degree stick would make it really go.
