I just rebuilt the linkage on my 1990 E30 cabbie. Got everything back together and forgot to put the heat shield in.......
Are there any tricks to putting it back in...it's the one above the cat......
heatshield.....
Moderator: martauto
-
appletree
- E30 Zone Addict
- Posts: 3479
- Joined: Fri Jan 20, 2006 11:00 pm
- Location: Retford
have you just done a short shift conversion and done all the bushes?? was it an easy job to rebuild?
-
mikey-t
- E30 Zone Regular
- Posts: 444
- Joined: Sun Aug 06, 2006 11:00 pm
fit a smoke alarm to your dash!
-
robmpulse
- E30 Zone Newbie
- Posts: 190
- Joined: Sun Apr 23, 2006 11:00 pm
- Location: Florida, USA
I rebuilt the linkage but using stock parts. Somehow, I snapped my selector rod in two.......
but now it's all together, and I can't figure out how to get this damn heat shield in
but now it's all together, and I can't figure out how to get this damn heat shield in
-
appletree
- E30 Zone Addict
- Posts: 3479
- Joined: Fri Jan 20, 2006 11:00 pm
- Location: Retford
how did you do that???
-
robmpulse
- E30 Zone Newbie
- Posts: 190
- Joined: Sun Apr 23, 2006 11:00 pm
- Location: Florida, USA
I have no idea.....
heat shield is back in. just took a fresh perspective and a pry bar ;)
after getting everything back together, while out on my first test drive, the selector rod started scrubbing against the dampner....... I took the selector rod out, bent it just a tad, and placed it back in. works like a champ!
heat shield is back in. just took a fresh perspective and a pry bar ;)
after getting everything back together, while out on my first test drive, the selector rod started scrubbing against the dampner....... I took the selector rod out, bent it just a tad, and placed it back in. works like a champ!