Car Ramps.
Moderator: martauto
-
FlappySocks
- E30 Zone Regular

- Posts: 860
- Joined: Sun Jan 22, 2006 11:00 pm
- Location: Fareham, Hampshire
Why is it all car ramps (the type you buy in halfords) seem to all be too short and too steep? Is there no market for cars with low clearance? I'm just looking at some of the cars passing my office window, and I'd say anything bigger than a Fiesta that doesn't look like it's riding on stilts, isn't going to get on a standard pair of ramps.
Stuart.
Stuart.
-
alane
- E30 Zone Regular

- Posts: 258
- Joined: Mon Jun 19, 2006 11:00 pm
- Location: erdington birmingham
i have a set of those ramps and there pants for sporty type cars i cant get my 325i or jaguar xjs onto them cars are too low / the angle is too steep.
u could try a couple of planks of wood to extend the ramp ,that has worked for me in the past . Im savin my pennies for a proper car lift .
u could try a couple of planks of wood to extend the ramp ,that has worked for me in the past . Im savin my pennies for a proper car lift .
-
FlappySocks
- E30 Zone Regular

- Posts: 860
- Joined: Sun Jan 22, 2006 11:00 pm
- Location: Fareham, Hampshire
I have owned 3 Jags, and 2 e30's and non of them would go on ramps. Best I can find are these, but they are not cheap, and on the wrong side of the pond.
http://www.dambachramps.com/oilchangedisplay.html
Stuart.
http://www.dambachramps.com/oilchangedisplay.html
Stuart.
-
alane
- E30 Zone Regular

- Posts: 258
- Joined: Mon Jun 19, 2006 11:00 pm
- Location: erdington birmingham
ive seen simular ones in the uk think it was a company called frost ,was in practical classics mag a while back think the were about 400£ .
i want a proper 4 post lift there about 1000£ for the manual one it jacks up and can be stored flat when not being used .
i want a proper 4 post lift there about 1000£ for the manual one it jacks up and can be stored flat when not being used .
-
ste
- Old Skooler

- Posts: 1173
- Joined: Mon Feb 07, 2005 11:00 pm
- Location: West Sussex
Halfords etc sell long yellow wheel chocks, they are supposed to be used for levelling camper vans but they make excellent low entry ramps to get onto your car ramps.
-
Bob_S
- Engaged to the E30 Zone

- Posts: 5412
- Joined: Sat Jun 11, 2005 11:00 pm
- Location: chester, cheshire
my is is down 35mm on H&R spings, to get it anywhere near lifted up I have to drive it onto bricks and if using ramps remove the front splitter
Bollocks to this 24v scrap!
-
bmwe30mtech
- Engaged to the E30 Zone

- Posts: 5288
- Joined: Thu Feb 03, 2005 11:00 pm
my car is on stilts! and still hits the ramps! 
1988 M3 EvoII, Macau Blue/EvoII trim
1989 325i Sport M Tech II, Diamond Black/Black leather
1989 325i Sport M Tech II, Diamond Black/Black leather
-
georob
- E30 Zone Camper

- Posts: 1106
- Joined: Thu Feb 03, 2005 11:00 pm
- Location: Aberdeenshire
I use a jack first to get the ramps under the wheels, total nightmare with it being lowered 60mm
-
m-dtech
- Unapproved Trader caution
- Posts: 2068
- Joined: Thu Sep 01, 2005 11:00 pm
-
georob
- E30 Zone Camper

- Posts: 1106
- Joined: Thu Feb 03, 2005 11:00 pm
- Location: Aberdeenshire
Def want/ need one of thosem-dtech wrote: http://www.restorationramps.co.uk/
-
FlappySocks
- E30 Zone Regular

- Posts: 860
- Joined: Sun Jan 22, 2006 11:00 pm
- Location: Fareham, Hampshire
Yeah, thay look great. Thanks for the link.
Stuart.
Stuart.
-
m-dtech
- Unapproved Trader caution
- Posts: 2068
- Joined: Thu Sep 01, 2005 11:00 pm
no problem, im gonna get a set myselfFlappySocks wrote:Yeah, thay look great. Thanks for the link.![]()
Stuart.
i had a car fall off ramps once and still got the scars to prove ! these look quite safe.
-
stonesie
- E30 Zone Addict

- Posts: 3277
- Joined: Sat Jan 07, 2006 11:00 pm
- Location: Doncaster
i had the same problem with the vw, the e30 on its standard stilts seams ok with my cheap ass method too....
an old scaffold board, chop in half and shape 1 end to fit into the steel ramp
an old scaffold board, chop in half and shape 1 end to fit into the steel ramp
-
kevin316i
- E30 Zone Regular

- Posts: 783
- Joined: Mon Jan 10, 2005 11:00 pm
I bought a set of ramps last Christmas and when I trid to use I realised that they are too steep! Need to get the front off the ground soon so plan to use some planks of timber. Pain in the butt 

Motronic to Megasquirt Plug and Play Guide