Retro-fitting Cruise Control

[AndrewL]

Can one of the experts please tell me (in detail) where the cable goes through the bulkhead? Below and to the left of my fuse box I only seem to have one hole through the bulkhead and it already has quite a few things running through it.

Many thanks for your help,

Andy Lee

[Brianmoooore]

If you look at the big rubber grommet through the bulkhead from the glove box side, you will see it has a number of partly formed holes.
I'm not familiar with the cruise loom but would expect it to have a grommet on it which should match one of these part cutouts.
You will have to finish removing the rubber from the appropriate hole with a scalpel or similar.

[charlE30]

If you look at the big rubber grommet through the bulkhead from the glove box side, you will see it has a number of partly formed holes.
I'm not familiar with the cruise loom but would expect it to have a grommet on it which should match one of these part cutouts.
You will have to finish removing the rubber from the appropriate hole with a scalpel or similar.

exactly as brian describes and use a bit of wire to pull the loom through, it's a tight fit and a bit fiddely but it does go

[AndrewL]

Many thanks guys, I'm planning to do the "inside" fix tomorrow; did the under-bonnet bit yesterday..

Andy