Where can I get one of these babies from?
It's time to swap my rear bearings.
Rear wheel bearing puller tool
Moderator: martauto
-
Ant
- Retired Team Member
- Posts: 10496
- Joined: Tue Dec 21, 2004 11:00 pm
- Location: PD+E dept :D
you dont need one fella !
got a V large lump hammer ?
you'll need a 30mm socket to drive the output flange out of the hub, then a 36mm socket to drive the bearing out of the housing
use the old bearing to knock the new ones in, saves damaging the new
the rest is nuts and bolts dude.
Lots of WD40, works for me
got a V large lump hammer ?
you'll need a 30mm socket to drive the output flange out of the hub, then a 36mm socket to drive the bearing out of the housing
use the old bearing to knock the new ones in, saves damaging the new
the rest is nuts and bolts dude.
Lots of WD40, works for me
Product Development and Endurance for Delphi.
Original performance chips, original works not unlicensed copies
Email FTW
Original performance chips, original works not unlicensed copies
Email FTW-
johnna
- E30Zone Irregular
- Posts: 1715
- Joined: Sat Sep 17, 2005 11:00 pm
- Location: In the hole
Hmmm Cheap reply... I like it!
It also involves mucho banging! Cool!
It also involves mucho banging! Cool!
-
Ant
- Retired Team Member
- Posts: 10496
- Joined: Tue Dec 21, 2004 11:00 pm
- Location: PD+E dept :D
foot long 1/2 inch extension bar is the ace in the hole though, also, to get better access, you may need to drop the rear box a tad
Product Development and Endurance for Delphi.
Original performance chips, original works not unlicensed copies Email FTW
Original performance chips, original works not unlicensed copies
Email FTW