Hi all
I have a metal pipe that goes from the fuel tank to the front of the car, at the front it joins to a rubber hose which does not go anywhere. It was sitting in the frame before I pulled it out.
This connects to the fuel tank behind the filter.
It's rusted more than the other lines so I was wondering if I should remove it if it doesn't do anything. Does anyone know what it is for?
Extra pipe to fuel tank
Moderator: martauto
-
Qasimahmed
- E30 Zone Newbie

- Posts: 101
- Joined: Tue Jul 28, 2020 6:49 pm
- Location: UK
You do not have the required permissions to view the files attached to this post.
-
TriggerFish
- E30 Zone Regular

- Posts: 507
- Joined: Sat Jun 30, 2012 11:00 pm
- Location: Aylesbury, Bucks
I had the same on mine. If memory serves, it was something to do with the charcoal canister/emissions stuff. I left mine off when I replaced the fuel pipes. I think that there is a wiki entry about it somewhere, and the need to make sure that it's not cut too close to the origin of the pipe - so that it still comes down under the fuel tank some of the way - something like that.
-
TriggerFish
- E30 Zone Regular

- Posts: 507
- Joined: Sat Jun 30, 2012 11:00 pm
- Location: Aylesbury, Bucks
Aha - found the link! https://www.e30zone.net/e30wiki/index.p ... n_Canister
-
Qasimahmed
- E30 Zone Newbie

- Posts: 101
- Joined: Tue Jul 28, 2020 6:49 pm
- Location: UK
Thanks a lot guys, out it comes. What do I do with the hole it passes through near the front passenger side. Anyway of stopping any rust etc?
-
V8turd
- E30 Zone Newbie

- Posts: 92
- Joined: Fri Dec 07, 2018 12:24 pm
Fuel breather. You can remove that hard line and terminate the breather up by the fuel filter. Just add a small piece of rubber hose there and job done
It's a job I've t do on mine shortly
It's a job I've t do on mine shortly
-
Qasimahmed
- E30 Zone Newbie

- Posts: 101
- Joined: Tue Jul 28, 2020 6:49 pm
- Location: UK
-
V8turd
- E30 Zone Newbie

- Posts: 92
- Joined: Fri Dec 07, 2018 12:24 pm
If you mean the hole in the turret where the pipe pokes out, nothing mate.Qasimahmed wrote: ↑Sat Mar 12, 2022 11:59 amWhat did you do with the tunnel it goes through towards the front
Just leave it be unless you're having welding done in the engine bay then you could have a circle patch welded in but I wouldn't worry about it to be honest
