Centre console removal
Moderator: martauto
-
oguz327
- Captain Armco

- Posts: 4174
- Joined: Tue Oct 25, 2005 11:00 pm
- Location: Hampshire
I am in the process of removing my carpet, i have taken interior seats front and rear compleatly out now.
Next as far as i know i need to remove my centre console, and accelerator pedal.
Can anyone tell me where the fixings for the centre console are and how to remove accelerator with out breaking the fixing?
Also anyone with any diagrams or pics or just general advise with this would be most welcome.
cheers
Next as far as i know i need to remove my centre console, and accelerator pedal.
Can anyone tell me where the fixings for the centre console are and how to remove accelerator with out breaking the fixing?
Also anyone with any diagrams or pics or just general advise with this would be most welcome.
cheers
-
dazleeds
- old skool raver

- Posts: 12883
- Joined: Fri Apr 01, 2005 11:00 pm
- Location: Empire Building @
centre console rear piece has a ten mm plastic nut under the rear ashtray
and the front part remove gear gaitor and theres a 10 plasi nut again near the gearstick apperture
there is also a plasi screw in drivers footwell next to clutch pedal
once them 3 are out just pull gently and slip console over the gearstick
not sure bout acc pedal sorry
hth
Daz
and the front part remove gear gaitor and theres a 10 plasi nut again near the gearstick apperture
there is also a plasi screw in drivers footwell next to clutch pedal
once them 3 are out just pull gently and slip console over the gearstick
not sure bout acc pedal sorry
hth
Daz
www.oldskoolfantasy.co.uk
in the shit,the one to blame,yeh its all my fault ;)
in the shit,the one to blame,yeh its all my fault ;)
-
eko
- Old timer
- Posts: 11531
- Joined: Sat Feb 05, 2005 11:00 pm
- Location: South Devon
Accelerator pedal is easy,remove the circlip at the top,pull it sideways of the linkage rod and pull it out of the floor!
It will be tight but force it to either side and it will come out.
If it breaks i got one here you can have but they are only cheap to buy new.
Centre console.
10mm nut under rear ashtray,another under the gear gaitor.
Back part will just lift out over the handbrake.Front part,there is a little bolt/screw(8mm i think)hidden.It is under the heater control part of the dash,a bit fiddly but not to bad.
Also down the sides of the console towards the front of the car,there should be two plastic twist screw things,remove these and i think thats it!
It will be tight but force it to either side and it will come out.
If it breaks i got one here you can have but they are only cheap to buy new.
Centre console.
10mm nut under rear ashtray,another under the gear gaitor.
Back part will just lift out over the handbrake.Front part,there is a little bolt/screw(8mm i think)hidden.It is under the heater control part of the dash,a bit fiddly but not to bad.
Also down the sides of the console towards the front of the car,there should be two plastic twist screw things,remove these and i think thats it!

-
dazleeds
- old skool raver

- Posts: 12883
- Joined: Fri Apr 01, 2005 11:00 pm
- Location: Empire Building @
good thinking forgot about the wee screw into the dash 
still beat ya too it tho
still beat ya too it tho
www.oldskoolfantasy.co.uk
in the shit,the one to blame,yeh its all my fault ;)
in the shit,the one to blame,yeh its all my fault ;)
-
oguz327
- Captain Armco

- Posts: 4174
- Joined: Tue Oct 25, 2005 11:00 pm
- Location: Hampshire
many thanks guys, all ive got is an e21 hannes with e30 updates in, but it might aswell be in japanese lol
will give it a go tomorow, gonna run the car with no carpet for a while to see where water is comming, am i right in thinkin i can put center console back in even with no carpet in place?
Thanks again fellas
will give it a go tomorow, gonna run the car with no carpet for a while to see where water is comming, am i right in thinkin i can put center console back in even with no carpet in place?
Thanks again fellas
-
dazleeds
- old skool raver

- Posts: 12883
- Joined: Fri Apr 01, 2005 11:00 pm
- Location: Empire Building @
yeah console will go in without carpet
but may be a bit loose and rattly
Daz
@ eko

but may be a bit loose and rattly
Daz
Last edited by dazleeds on Wed Feb 15, 2006 6:18 pm, edited 1 time in total.
www.oldskoolfantasy.co.uk
in the shit,the one to blame,yeh its all my fault ;)
in the shit,the one to blame,yeh its all my fault ;)
-
dazleeds
- old skool raver

- Posts: 12883
- Joined: Fri Apr 01, 2005 11:00 pm
- Location: Empire Building @
lol and again
eko
come on old fella
eko
come on old fella
www.oldskoolfantasy.co.uk
in the shit,the one to blame,yeh its all my fault ;)
in the shit,the one to blame,yeh its all my fault ;)
-
oguz327
- Captain Armco

- Posts: 4174
- Joined: Tue Oct 25, 2005 11:00 pm
- Location: Hampshire
cool Daz i can live with that
is the carpet gonna be a bastard to put back in?
mabie need 2 people to do it?
is the carpet gonna be a bastard to put back in?
mabie need 2 people to do it?
-
dazleeds
- old skool raver

- Posts: 12883
- Joined: Fri Apr 01, 2005 11:00 pm
- Location: Empire Building @
can be a pain at the bulkhead/ heaterbox area if i remember right
and be very gentle with it when pulling out as they can rip veryvery easily
just take ya time with it youll be fine mate
Daz
EKO where are ya mate??
and be very gentle with it when pulling out as they can rip veryvery easily
just take ya time with it youll be fine mate
Daz
EKO where are ya mate??
www.oldskoolfantasy.co.uk
in the shit,the one to blame,yeh its all my fault ;)
in the shit,the one to blame,yeh its all my fault ;)
-
oguz327
- Captain Armco

- Posts: 4174
- Joined: Tue Oct 25, 2005 11:00 pm
- Location: Hampshire
Cheers Daz and Eko lol you boys are fast.
Ill give it ago tomorow and fingers crossed not too much rust, so far passenger side is looking good.
Many thanks guys, ill post up tomorow let ya know how i got on
Ill give it ago tomorow and fingers crossed not too much rust, so far passenger side is looking good.
Many thanks guys, ill post up tomorow let ya know how i got on
-
eko
- Old timer
- Posts: 11531
- Joined: Sat Feb 05, 2005 11:00 pm
- Location: South Devon
I give upEKO where are ya mate??

-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Accelerator pedal is not meant to be reuseable once its been removed, but in practice they usually come out OK. Only ever broke one that I can remember.
The carpet will be very tight under the heater, and its easiest if you cut around this piece with a sharp craft knife, leaving the piece under the heater in place. The cut will be completely covered by the front console.
MIND THE WIRES UNDER THE CARPET.
The carpet will be very tight under the heater, and its easiest if you cut around this piece with a sharp craft knife, leaving the piece under the heater in place. The cut will be completely covered by the front console.
MIND THE WIRES UNDER THE CARPET.

