Good evening all,
A few years ago I fitted an after market remote system for the central locking. This working fine for a while, but then became intermittent and eventually stopped working completely. All it did then was slowly drain my battery while my E30 was in the garage.
So, when I recently had the dash out I thought I would remove the remote system, this I did and it was quite easy to identify where the remote wires had been spliced into the existing loom. But, I am now left with a central locking system that does not work at all. Could someone give me a little guidance on how to troubleshoot this and/or where to start looking for the problem?
Thanks very much.
Central Locking Not Working after Remote Removal
Moderator: martauto
-
BenHar
- E30 Zone Addict

- Posts: 3081
- Joined: Sun Jul 11, 2010 11:00 pm
- Location: Reigate, Surrey
Did it work using the key in the lock before you removed the remote system?
Ben
Ben
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49359
- Joined: Mon Jan 10, 2005 11:00 pm
Find the two E30 loom wires which the remote system lock and unlock request wires were spliced into (the ones you removed) - they should be green/blue and yellow/blue, and use a piece of wire to briefly earth each one in turn. This should lock and unlock the car.


