Is this the correct thing for a 325i??? (From GSF)
B93490 WATER TEMPERATURE SENSOR General Use. Most Injection Models. 2 Pin Blue Cover 10.00
Thanks
Blue Temp Sensor
Moderator: martauto
-
Simon
- E30 Zone Team Member
- Posts: 14939
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: South Wales
Yes.
-
pete325i
- E30 Zone Newbie
- Posts: 73
- Joined: Tue Jan 11, 2005 11:00 pm
- Location: Near Birmingham
Great! Thanks, I'll go and get one now.
Are they easy to change, any tricks?
Cheers
Are they easy to change, any tricks?
Cheers
-
Jami
- E30 Zone Newbie
- Posts: 41
- Joined: Tue Dec 06, 2005 11:00 pm
I just repalced one on my 320i, which apparently has a 2.5litre head on it (still not verified).
I found the easiest way was to discconect the injector wiring rail and move it towards the bulk head. I had to disconnect the breather pipe from the cylnder head to do this.
Then disconnect both the blue sensor and the brown sensor (temperature gauge). Then you should be able to get a socket on top of the sensor. It is a 19mm deep socket you need, but i used the large spark plug socket i have.
Just remove the old one and put the new one in. Believe me, if your old one is nackered the end result is worth it!!!!!!
I found the easiest way was to discconect the injector wiring rail and move it towards the bulk head. I had to disconnect the breather pipe from the cylnder head to do this.
Then disconnect both the blue sensor and the brown sensor (temperature gauge). Then you should be able to get a socket on top of the sensor. It is a 19mm deep socket you need, but i used the large spark plug socket i have.
Just remove the old one and put the new one in. Believe me, if your old one is nackered the end result is worth it!!!!!!
320i SE on 15" BBS in grey with leather to match