My car is makeing a banging nose when I go over bumps.
Sounds like it's comeing from the front drives side wheel not sure thow.
I changed both front strut top mounts and all the ball joints on both front wishbones have also bin changed.
It needs the trailing arm bushes need changing on thwr back gona do that next month.
Is some one could give me some advice on what it could be please.
banging nose going over bumps
Moderator: martauto
-
sh123
- E30 Zone Newbie

- Posts: 33
- Joined: Tue Aug 05, 2014 11:00 pm
if its more of a knocking noise rather than banging anti roll bar link road possibly?
have a look underneath and pull on the arb to see if there any play in it
have a look underneath and pull on the arb to see if there any play in it
-
Bazo187
- E30 Zone Newbie

- Posts: 71
- Joined: Sat Jan 26, 2013 11:00 pm
- Location: Blackburn
Nice one. I''ll check it out asap.
-
Bazo187
- E30 Zone Newbie

- Posts: 71
- Joined: Sat Jan 26, 2013 11:00 pm
- Location: Blackburn
Nice one. I''ll check it out asap.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Had a loud banging from the front of an E30 once that turned out to be a worn manual steering rack. Don't think a power rack could wear that badly without leaking though.
-
Eddie25
- E30 Zone Newbie

- Posts: 37
- Joined: Fri Dec 29, 2006 11:00 pm
- Location: Gloucestershire
I had this problem on mine. I changed just about everything bush and suspension related until I changed the dampers themselves. Problem solved!
Used to make a horrible knocking over bumps you could actually feel come through the steering wheel.
Used to make a horrible knocking over bumps you could actually feel come through the steering wheel.
Rust is lighter than carbon fibre.
-
Eddie25
- E30 Zone Newbie

- Posts: 37
- Joined: Fri Dec 29, 2006 11:00 pm
- Location: Gloucestershire
PS Dampers showed no signs of leaking and passed the old rebound test no problem.
Rust is lighter than carbon fibre.
-
Bazo187
- E30 Zone Newbie

- Posts: 71
- Joined: Sat Jan 26, 2013 11:00 pm
- Location: Blackburn
Thanks a lot people
gona have a good look at all of the above on the weekend
gona have a good look at all of the above on the weekend
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
I had the same problem. It turned out to be a worn shock absorber. But by the time I had worked that out I had replaced the control arm and other odds and ends.
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
is your wife locked in the boot? they often complain when you go over a bump in this situation
-
HairyScreech
- Engaged to the E30 Zone

- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
The damper knock might have been the piston on the damper breaking free from the shaft, this creates slack between the piston and the shaft and causes them to slap together on the change of direction (compression to rebound)
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
