Power steering Heavy

Need technical Q/A then you're in the right place

Moderator: martauto

trojen
E30 Zone Newbie
E30 Zone Newbie
Posts: 94
Joined: Fri Apr 02, 2010 11:00 pm
Location: West Midlands

Post Sat Jul 12, 2014 10:24 am

After tuning around 180 degrees in a side road my steering has become very heavy.

My initial thoughts were that the belts flung off when on full lock but thats still connected.

There are no leaks and the reservoir is full although seems a little thin, i'm going to change the fluid now hopefully that helps.

Are the pumps a know failure point? The cars a 1993 M40 Tourer.

Cheers
Image

318is
316i Touring
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Sat Jul 12, 2014 11:17 am

Belt might be on, but it may be loose or so old that it's gone glassy (which causes slipping).

I've not heard of a pump failing on here, but it's a moving part so that could always happen.
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Sat Jul 12, 2014 11:37 am

I had a power steering pump fail three or four years back,thing was whining worse than 'er indoors,about an inch of end float at the pulley! :o:
Youth is wasted on the young.
trojen
E30 Zone Newbie
E30 Zone Newbie
Posts: 94
Joined: Fri Apr 02, 2010 11:00 pm
Location: West Midlands

Post Sat Jul 12, 2014 3:18 pm

So i've changed the belt and fluids and still no joy. Pumps next.

The belt is spinning the pulley but its almost as if drive shaft to the pump has sheered.

daimlerman - i couldn't here the typical whining nose although it is a M40 work horse so i probably couldn't here it over the tappets........
Image

318is
316i Touring
sindako
E30 Zone Newbie
E30 Zone Newbie
Posts: 57
Joined: Sun Jul 13, 2014 11:00 pm
Location: Jordan, Middle East

Post Mon Jul 14, 2014 6:50 pm

first Check out the Fluid . if it's goin from red to Black that mean your pump is out and it's taking the driven steel from it to the rack which makes it heavy .

if that is not your prob .

then

if you know how to do it .

i recommend Getting a rebuild kit .
Also when buying get the ZF branded ones .
They're better then meyle .

Needs alot of work but it'll run good .