How do I reset my rear bumper and front bumper

[BROOMY]

The backs lower than it should be.
The sides are lower than the rest of it.

[jimbom30cab]

if this is a facelift car then the runners the bumper sit on use eccentric holes I think , which can be adjusted to get a neat fit.

[BROOMY]

Where are the holes?
Yes it is a facelift.
The backs fine just the sides not. It's to low atm

[jimbom30cab]

take the bumper off and look at the slider brackets at the side, they can be adjusted

[BROOMY]

How you take the bumper off ?

[jimbom30cab]

For the rear, 2 large bolts - star shaped fittings - under the rear panel

[BROOMY]

The bit of plastic here?
http://i593.photobucket.com/albums/tt17 ... vqgrav.jpg

[bumpygt]

On the main long section, on front either sides of the number plate, look of the hole on the under side of the bumper. And similar area on the rear.

[bmw9818]

Torx T55 bolts or T45 or T50 one of the three, undo and pull off

[Topblag]

T55 Torx headed bolts. Soak them in wd40 or similar 24 hrs in advance, try and pull the bolt down as it's being loosened and use a 1/2 drive T55 socket, I broke three 3/8 drive T55s in a month.