rev counter not working

[frenchi]

rev gauge not working any idears

[Brianmoooore]

Prime suspect is the SI board batteries.

[frenchi]

you are allways there mate ,what and where are they

[Grrrmachine]

All the information's at your fingertips:

http://www.e30zone.net/e30zonewiki/inde ... ot_Working

http://www.e30zone.net/e30zonewiki/inde ... _Batteries

[frenchi]

ok changed battery board over from one that was ok,reving and working ,pluged into mine and nothing only when you switch off it flickers.help brian

[Grrrmachine]

And did you read the "Rev Counter Not Working" page?

[frenchi]

yep went through that but it did not help.

[Grrrmachine]

If you've swapped the SI batteries with known good ones, and you're absolutely sure the black wire is giving a clean signal from the ECU to the clock, then either your clock itself is broken or your engine isn't actually turning.

[frenchi]

thanks for that I understand what you have wrote,i suffer from dislexier .its hard to understand and red some stuff ,I have tried the site but some stuff wont come up I don't think I have the right hard where,i will have another go tomorrow I think the signal is trying to get through that's why the needle was jumping ,thanks again, rick