Questions
Moderator: martauto
-
adam_2922
- E30 Zone Newbie

- Posts: 128
- Joined: Mon Jan 21, 2013 11:00 pm
Firstly are the standard brake disks on an e30 vented?
Secondly what is the code on a limited slip disk on an e30, a friend of mine insists that my car has an LSD, I drive it and insidt that it hasn't.
Also what is the lowest ratio LSD that you can get for an e30 (without ordering specially)
Finally how much will it cost to get a garage (or just a person that knows what they are doing) to fit a set of coilovers. I live in london. Does anybody have any recommendation on kit aswell? I have just fitted new wheels (replaced the horrible buckled aftermarkets) and now the nose looks like it's scared of the road. I only use the car on the road it is a 1991 318i cab so theres no need for the suspension to be too advanced.
Thanks alot
Secondly what is the code on a limited slip disk on an e30, a friend of mine insists that my car has an LSD, I drive it and insidt that it hasn't.
Also what is the lowest ratio LSD that you can get for an e30 (without ordering specially)
Finally how much will it cost to get a garage (or just a person that knows what they are doing) to fit a set of coilovers. I live in london. Does anybody have any recommendation on kit aswell? I have just fitted new wheels (replaced the horrible buckled aftermarkets) and now the nose looks like it's scared of the road. I only use the car on the road it is a 1991 318i cab so theres no need for the suspension to be too advanced.
Thanks alot
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
Only on the 51mm Strut type cars I believe, i.e. 325i, 318is.Firstly are the standard brake disks on an e30 vented?
it will depend on whether they are the type that need to be welded to the strut or are direct replacement for the inserts.Finally how much will it cost to get a garage (or just a person that knows what they are doing) to fit a set of coilovers
Fitting a set of good quality springs and dampers will get your car lower and will handle perfectly well. Eibach pro kit, H + R Cup kits come recommened for the springs, and matched to Blistein B4, B6, B8 or Boge Turbo dampers.
Spings and dampers are easily done with a jack, stands and some basic tools. If you know what your doing the fronts can be done in approx 2 hours and the rears in an hour.
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
Lots of info in the wiki as well.
http://www.e30zone.net/e30zonewiki/inde ... akes#Discs
http://www.e30zone.net/e30zonewiki/index.php/Suspension
P.S. Getting a garage to do the work very few people can tell you a price as it will all depend on the garages hourly rate.
http://www.e30zone.net/e30zonewiki/inde ... akes#Discs
http://www.e30zone.net/e30zonewiki/index.php/Suspension
P.S. Getting a garage to do the work very few people can tell you a price as it will all depend on the garages hourly rate.
-
adam_2922
- E30 Zone Newbie

- Posts: 128
- Joined: Mon Jan 21, 2013 11:00 pm
Thanks for the info. The wiki is very good
-
Chris_B86
- E30 Zone Camper

- Posts: 1167
- Joined: Mon Jul 23, 2012 11:00 pm
To check if your has an LSD, jack the rear end of the car up, spin one rear wheel, if the other wheel spins the opposite way, it's an LSD, if they spin the same way it's an open diff. I'd be very surprised if a 318i has an LSD though, unless it's been retro fitted

1990 E30 325i Sport Sterling Silber
1999 E36 323i Sport Touring Techno Violet
-
j2b
- E30 Zone Regular

- Posts: 884
- Joined: Fri May 21, 2010 11:00 pm
- Location: Kent
this ^^^Rtaylor2208 wrote:Only on the 51mm Strut type cars I believe, i.e. 325i, 318is.Firstly are the standard brake disks on an e30 vented?
Finally how much will it cost to get a garage (or just a person that knows what they are doing) to fit a set of coilovers
Fitting a set of good quality springs and dampers will get your car lower and will handle perfectly well. Eibach pro kit, H + R Cup kits come recommened for the springs, and matched to Blistein B4, B6, B8 or Boge Turbo dampers.
Spings and dampers are easily done with a jack, stands and some basic tools. If you know what your doing the fronts can be done in approx 2 hours and the rears in an hour.
your car being a cab it should already have the 51mm struts fitted
the discs are easy to change too.
89 more door 6 pot
-
adam_2922
- E30 Zone Newbie

- Posts: 128
- Joined: Mon Jan 21, 2013 11:00 pm
South east. I live in beckenham.... And it may be a turd but it's not rusty anymore! Its just spend two months in the bodyshop!
The car before I bought it has had a few bits retrofitted. It has vented disks front and back. Battery moved to the rear ect.... And it was probably the person who did this that made the engine need rebuilding!
The car before I bought it has had a few bits retrofitted. It has vented disks front and back. Battery moved to the rear ect.... And it was probably the person who did this that made the engine need rebuilding!
-
j2b
- E30 Zone Regular

- Posts: 884
- Joined: Fri May 21, 2010 11:00 pm
- Location: Kent
think you"ll find its the other way around .Chris_B86 wrote:To check if your has an LSD, jack the rear end of the car up, spin one rear wheel, if the other wheel spins the opposite way, it's an LSD, if they spin the same way it's an open diff. I'd be very surprised if a 318i has an LSD though, unless it's been retro fitted
if turning one wheel and the other goes in the same direction =lsd,
if it spins opposite = open diff.
89 more door 6 pot
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
You might want to try again on that one!Chris_B86 wrote: spin one rear wheel, if the other wheel spins the opposite way, it's an LSD, if they spin the same way it's an open diff.
-
Chris_B86
- E30 Zone Camper

- Posts: 1167
- Joined: Mon Jul 23, 2012 11:00 pm
Oops my bad, losing the will to live at work, half asleep

1990 E30 325i Sport Sterling Silber
1999 E36 323i Sport Touring Techno Violet
-
capnmchl
- E30 Zone Camper

- Posts: 1141
- Joined: Mon Feb 20, 2012 11:00 pm
- Location: Exeter, Devon
Plus it only really confirms it if the car is in gear when you spin it. Otherwise you may end up spinning the whole carrier which will spin the whole lot one way.
-
polsta
- Married to the E30 Zone

- Posts: 10322
- Joined: Fri Oct 09, 2009 11:00 pm
- Location: portsmouth
also, the LDS will have a little metal tag on it- wire brush it if grubby to reveal the serial number, lsd start with "S" , bit like doing a scratch card really 
-
magpie
- Old Skooler

- Posts: 28035
- Joined: Sun Jun 29, 2008 11:00 pm
- Location: Consett,Durham.
lsd tests are free here 



m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds
-
adam_2922
- E30 Zone Newbie

- Posts: 128
- Joined: Mon Jan 21, 2013 11:00 pm
not with a brand new set of toyo's on they aren't!! 
-
Chris_B86
- E30 Zone Camper

- Posts: 1167
- Joined: Mon Jul 23, 2012 11:00 pm
It'll just scrub them in for proper useadam_2922 wrote:not with a brand new set of toyo's on they aren't!!

1990 E30 325i Sport Sterling Silber
1999 E36 323i Sport Touring Techno Violet
-
magpie
- Old Skooler

- Posts: 28035
- Joined: Sun Jun 29, 2008 11:00 pm
- Location: Consett,Durham.
i do the tests for free


m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds
-
ross_jsy
- Married to the E30 Zone

- Posts: 7307
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Jersey, C.I.
Jack one side up with the other wheel on the ground, car out of gear and turn the wheel that's in the air. If it doesn't turn/hard to turn it's a slipper.
There are figures available somewhere to check if your LSD is within factory specs with a torque wrench. Most aren't any more.
There are figures available somewhere to check if your LSD is within factory specs with a torque wrench. Most aren't any more.
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
All factory cabbies have vented front discs.
Solid front discs only on 316/316i saloon,these could include a Baur conversion.
318i cabbie with manual 'box should have a small case 4:27 diff,I think,cannot recall hearing about an LSD in this ratio.
318iS had LSD as option,on a 4:1 ratio.
Solid front discs only on 316/316i saloon,these could include a Baur conversion.
318i cabbie with manual 'box should have a small case 4:27 diff,I think,cannot recall hearing about an LSD in this ratio.
318iS had LSD as option,on a 4:1 ratio.
Youth is wasted on the young.
