Hi
I found a Torque Converter from and old 528i. Connected to a 4hp22 - the same as my box.
Will this fit on my 323i 4hp22? Will it be neccessary to change the flywheel over? Is it physically too large to fit in the bellhousing?
Cheers
Martin
Will it fit?
Moderator: martauto
-
Martin323i
- E30 Zone Newbie
- Posts: 111
- Joined: Fri Sep 09, 2005 11:00 pm
- Location: Mossel Bay, South Africa
-
Demlotcrew
- E30 Zone Team Member
- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
The ETK say no!
Andrew
Andrew
-
Martin323i
- E30 Zone Newbie
- Posts: 111
- Joined: Fri Sep 09, 2005 11:00 pm
- Location: Mossel Bay, South Africa
damn.
Well, back to searching then.
Well, back to searching then.
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Can't always go by the ETK (unless it gives dimensions).
The slightest change in spec or design will result in a different part number.
The slightest change in spec or design will result in a different part number.
-
Martin323i
- E30 Zone Newbie
- Posts: 111
- Joined: Fri Sep 09, 2005 11:00 pm
- Location: Mossel Bay, South Africa
Yup, Lockup clutch engaging whenever it wants to or doesn't when it should. Started with the rattle just off idle but has now turned into a loud scraping noise all the time while in drive and reverse. I think the lockup clutch probably engaged permanently - even if not completely - causing the noise.Argos wrote:What's wrong with yours anyway?? Don't tell me, the tinny rattle just off idle and the loss of the 56mph lock up??
Oi