318is radiator
Moderator: martauto
-
Emm3
- E30 Zone Regular

- Posts: 866
- Joined: Sat Apr 08, 2006 11:00 pm
I've got a leaky radiator that needs to be changed, do the m40 engines share the same part and if not how can I tell an I.s one?
-
Scruffymurphy
- E30 Zone Regular

- Posts: 775
- Joined: Sun Sep 24, 2006 11:00 pm
- Location: Ireland
The IS rad is bigger than the M40 one. The M40 will work fine though. I've used them before without issue.
-
Emm3
- E30 Zone Regular

- Posts: 866
- Joined: Sat Apr 08, 2006 11:00 pm
well i got a rad and intended to fit it today, come home and think the pikeys have been around and taken the old one from my garden, i'm quite surprised as it wasnt on display or anything. Now in the papers for my car there was a recall note for a dodgy pressure cap so i presume this had been replaced under recall. As the old rad has now gone i've got the new one with a cap but i'm not sure its the right one, how do i tell?
-
magpie
- Old Skooler

- Posts: 28035
- Joined: Sun Jun 29, 2008 11:00 pm
- Location: Consett,Durham.
is there a number on the cap ?

m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds
-
Emm3
- E30 Zone Regular

- Posts: 866
- Joined: Sat Apr 08, 2006 11:00 pm
Theres number 140 on the top of the cap
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
iS cap should be 2 bar, not 1.4.
-
Emm3
- E30 Zone Regular

- Posts: 866
- Joined: Sat Apr 08, 2006 11:00 pm
Will this cap release presseure too soon then and is there no point using it
-
Emm3
- E30 Zone Regular

- Posts: 866
- Joined: Sat Apr 08, 2006 11:00 pm
Guys the 2nd hand rad I bought is leaking so time for a new one cant seem to find an I.s one will an m40 one work for deffo and does it matter if it's 1.6 or 1.8? M40
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Fitting a second hand radiator is akin to using second hand oil filters and brake pads!
Radiators are service items, and should be replaced with new at 100,000 mile intervals.
http://www.carparts4less.co.uk/car-radiator.
Radiators are service items, and should be replaced with new at 100,000 mile intervals.
http://www.carparts4less.co.uk/car-radiator.
-
78gizmo
- E30 Zone Regular

- Posts: 265
- Joined: Fri Nov 16, 2007 11:00 pm
- Location: Torbay, South Devon
I have got an M42 318is engine in my touring, using the M40 318i radiator with no issues at all. It runs at just under half way on the temp gauge under all conditions.
-
adit
- Married to the E30 Zone

- Posts: 13727
- Joined: Wed Jun 20, 2007 11:00 pm
- Location: portsmouth
i'm sure i have an M42 radiator here somewhere if you want the proper one 

E30 Parts Galore!! 07901 888019
[quote="bss325i"]
Get a f* grip,we are talking about 20+yr.old sub £10k cars here,NOT the crown jewels!
-
Emm3
- E30 Zone Regular

- Posts: 866
- Joined: Sat Apr 08, 2006 11:00 pm
Rite well I got hold of a brand new nissen radiator for a 1.8 I knew it would be smaller but based on what I've read it should work ok I measured the 2 and there's about an inch difference in width. Now what I did notice is that where the fan shroud has 2 clips at the top I thought the rads may be different but the shroud woul still fit, wrong! the distance between the holes in the rad for the clips also differs which means I also need a smaller shroud, this got me thinking what other differences are there? Will the the lower pins will also be narrower so will it even sit on the lower rad mounts ok don't want to start changing other parts just to get this to work.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
You'll need to change the LH lower mount to a 90mm one, but it's only a couple of quid brand new from BMW.
-
Emm3
- E30 Zone Regular

- Posts: 866
- Joined: Sat Apr 08, 2006 11:00 pm
Thank you mr Moore, is that the n/s mount?Brianmoooore wrote:You'll need to change the LH lower mount to a 90mm one, but it's only a couple of quid brand new from BMW.
Just a few more questions
Are all the pipes the same size?
Are all the viscous fans the same because if I change the fan shroud for a 1.8 will the m42 fan foul the smaller shroud?
Thanks
-
Andyboy
- Alpina Colada
- Posts: 12577
- Joined: Mon Sep 11, 2006 11:00 pm
- Location: Notts
The 318iS rad is the same as the 24v E34 520i and 525i.
