Removing Sideskirts
Moderator: martauto
-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
Thinking of getting the skirts off for a clean may or may not go back on can someone point me in the direction of an idiots guide? I assume they bolt on from underneath
Seen this but its not too clear to me
http://www.e30zone.net/e30zonewiki/imag ... Seiten.pdf
Seen this but its not too clear to me
http://www.e30zone.net/e30zonewiki/imag ... Seiten.pdf
Last edited by 318isPMK on Thu May 03, 2012 11:58 pm, edited 1 time in total.
-
Rav335uk
- E30 Zone Meets/Events Team

- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
Did you get to the part all written in English?? 

If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Shouldn't be any screws underneath
You'll have to get the holes filled in that the top clips sit in if you're leaving them off. Plus any rust they're hiding.
You'll have to get the holes filled in that the top clips sit in if you're leaving them off. Plus any rust they're hiding.
-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
[quote="318isPMK"Does that make sense?[/quote]
Not at all.
There shouldn't be any screws at all. The Wiki link you posted shows everything you need to know. There are;
7 holes along the top of the skirt the top clip push into.
2 plastic rivet in the rear arch
Then there are a load of clips on the under side of the skirts, can't remember how many but they are easy to see.
1 screw on the bottom of the wing, this is fitted to all E30s.
Not at all.
There shouldn't be any screws at all. The Wiki link you posted shows everything you need to know. There are;
7 holes along the top of the skirt the top clip push into.
2 plastic rivet in the rear arch
Then there are a load of clips on the under side of the skirts, can't remember how many but they are easy to see.
1 screw on the bottom of the wing, this is fitted to all E30s.
-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Ahhhhh, no point looking at a fitting guide fo SE skirts then!
Tech 1 skirts should be screwed on along the bottom with hex screws, screws into brackets on the front wings and plastic rivets on the rear and then similar clips along the top like the SE skirts.
Tech 1 skirts should be screwed on along the bottom with hex screws, screws into brackets on the front wings and plastic rivets on the rear and then similar clips along the top like the SE skirts.
-
320iAN
- E30 Zone Camper

- Posts: 1395
- Joined: Sat Sep 16, 2006 11:00 pm
- Location: West Scotland
Paul.. the skirts on your car were fitted by the owner i bought it from, i had never taken them off but they looked to have the original fitting clips on the underside (along the cill lip) then they had just been screwed in to the lip on each wheel arch, if you look behind the skirts from an above angle they look like they have been either bonded or heavy double sided tape used to hold them to the cill.
hope this help's
hope this help's

-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
-
pacerpete
- E30 Zone Team Member

- Posts: 18165
- Joined: Sun Jan 23, 2005 11:00 pm
- Location: Iver heath. South bucks.
They WILL be structural, leave them on ! 
-
ross_jsy
- Married to the E30 Zone

- Posts: 7307
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Jersey, C.I.
I'd be more nervous about what you might uncover 
-
Jhonno
- Homo Hair
- Posts: 20362
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: FLAT, FLAT, FLAT!!
PMSL!!pacerpete wrote:They WILL be structural, leave them on !
-
ross_jsy
- Married to the E30 Zone

- Posts: 7307
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Jersey, C.I.
Eloquent as always Petepacerpete wrote:They WILL be structural, leave them on !
-
Rich320I
- E30 Zone Camper

- Posts: 1272
- Joined: Tue Dec 06, 2011 11:00 pm
- Location: Worcester
Also as higher powers on the zone have informed me
, they shouldn’t be bonded on but correctly fitting to make removal easier, im watching with interest as mine are bonded on to, I want to see how much of the cill comes away with the skirt 
-
pacerpete
- E30 Zone Team Member

- Posts: 18165
- Joined: Sun Jan 23, 2005 11:00 pm
- Location: Iver heath. South bucks.
Rich320I wrote:Also as higher powers on the zone have informed me, they shouldn’t be bonded on but correctly fitting to make removal easier, im watching with interest as mine are bonded on to, I want to see how much of the cill comes away with the skirt
What sill ?
-
Rich320I
- E30 Zone Camper

- Posts: 1272
- Joined: Tue Dec 06, 2011 11:00 pm
- Location: Worcester
my thoughts exactly pete 
-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
-
ross_jsy
- Married to the E30 Zone

- Posts: 7307
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Jersey, C.I.
Whip em off, what's the worse that could happen.
Just remember to add a dust pan and brush/bin bags/skip to the list of tools (delete as appropriate)
I feel for ya bud!
Just remember to add a dust pan and brush/bin bags/skip to the list of tools (delete as appropriate)
I feel for ya bud!
-
Rich320I
- E30 Zone Camper

- Posts: 1272
- Joined: Tue Dec 06, 2011 11:00 pm
- Location: Worcester
To be fair bud, id take them off as a precaution if there is any rot lurking behind its better to catch it now and get it sorted. Fingers crossed itl be minty mint you do deserve abit of luck with that car 
-
pacerpete
- E30 Zone Team Member

- Posts: 18165
- Joined: Sun Jan 23, 2005 11:00 pm
- Location: Iver heath. South bucks.
Man up, get them off and take loads of pics ! 
-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
-
ross_jsy
- Married to the E30 Zone

- Posts: 7307
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Jersey, C.I.
To be honest, if you take them off and find a 50p sized blister now that isn't rotten properly it's going to take you the cost of a wire wheel, kurust, etch primer, can of spray and some under seal/waxoil.
Leave it a year and what could be £10-20 outlay and half an hour with a grinder could turn into having to get some welding done.
And if you do find something horrific, tell the zone it was factory mint, bond those fuckers on like no tomorrow and shove the turd on piston heads sharpish
Leave it a year and what could be £10-20 outlay and half an hour with a grinder could turn into having to get some welding done.
And if you do find something horrific, tell the zone it was factory mint, bond those fuckers on like no tomorrow and shove the turd on piston heads sharpish
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Whip 'em off; what's the worst that could happen?
Oh yeah...

Oh yeah...

'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
ross_jsy
- Married to the E30 Zone

- Posts: 7307
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Jersey, C.I.
Like I said:
I would rather know if my turd was rotten with some tech1 side skirts nailed over it than not knowross_jsy wrote:And if you do find something horrific, tell the zone it was factory mint, bond those ******* on like no tomorrow and shove the turd on piston heads sharpish
-
kieran325
- Old Skooler

- Posts: 5015
- Joined: Sun Oct 30, 2005 11:00 pm
If I'm free I might be able to help him outpacerpete wrote:Man up, get them off and take loads of pics !
-
318isPMK
- E30 Zone Camper

- Posts: 1499
- Joined: Tue Jan 10, 2012 11:00 pm
-
Rich320I
- E30 Zone Camper

- Posts: 1272
- Joined: Tue Dec 06, 2011 11:00 pm
- Location: Worcester
he is good he also parks in my street 
-
320iAN
- E30 Zone Camper

- Posts: 1395
- Joined: Sat Sep 16, 2006 11:00 pm
- Location: West Scotland
i wouldn't worry to much as the car was stripped to the bare metal for it's respray and the guy i got it from say's the Tech 1 skirts were added about 4/5 mths after (hence how they look a slightly different shade) and the sill's are suppose to be black, look closely at yours, there red which does indicate they were painted when the car was318isPMK wrote:Yeah I seen that and its making me nervous about damaging the paint!
Boyd knew the car before it got painted & he also told me in the past that he could never remember the car having any worrying rust before the paint work, just a badly covered scratch on a quarter panel.




