Removing Outer Sill to repair Inner

General E30 related discussions -
Please put technical questions in E30 Tech Help forum below

Moderator: martauto

Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Mon Apr 23, 2012 4:30 pm

I need to remove a new (two year old) outer sill to repair the inner sill, which has almost completely dissolved along the bottom.

But where do I make the cuts? I can see the spot welds at the bottom of the doors, but what about the base of the A-, B- and C-pillar to the rear arch? Is it worth trying to cut out the original weld, or should I just lop off the sill in the straightest, neatest cuts I can make and weld them back up afterwards?
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Mon Apr 23, 2012 5:46 pm

Further inspection:

Image

Seems I can slice vertically through the outer sill just before the A-pillar, and in front of the C pillar and beam support plate, so that's a minor relief. Still furious about how the bodyshop left the sills in that condition though.
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Fri Apr 27, 2012 12:24 pm

Well that's the outer sill open. Still fuming over how bad this got without me knowing:

Image

Check your sills, people!
Tom_Maverick
E30 Zone Camper
E30 Zone Camper
Posts: 1343
Joined: Wed Aug 25, 2010 11:00 pm
Location: Brighton

Post Fri Apr 27, 2012 12:26 pm

wow, it's amazing how these buggers rot right under your nose, a clean car 12 months ago can develop all kinds of nasties! regular checkups are definitely recommended!

looks like it'll be fun to repair.. best of luck!
Image
bab-91
Married to the E30 Zone
Married to the E30 Zone
Posts: 7174
Joined: Thu Jan 06, 2011 11:00 pm
Location: Northern Ireland

Post Fri Apr 27, 2012 12:39 pm

Grrrmachine wrote: Check your sills, people!

:eek: I dont want to look at mine after seeing that!!
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Fri Apr 27, 2012 2:40 pm

It's not as awful as I thought. It had rusted to about 5mm below the spot welds that hold the floor pan in place, so I was able to run a slit disc along it and get most of the crust off. There's nothing holding the drivers seat up now though 8O

Image
BATTS91
E30 Zone Squatter
E30 Zone Squatter
Posts: 1764
Joined: Sat May 01, 2010 11:00 pm
Location: clacton on sea essex

Post Sat Apr 28, 2012 3:34 am

bab-91 wrote:
Grrrmachine wrote: Check your sills, people!

:eek: I dont want to look at mine after seeing that!!
my thought too im scard to even take headlining away justincade i find horrors lol