I need to remove a new (two year old) outer sill to repair the inner sill, which has almost completely dissolved along the bottom.
But where do I make the cuts? I can see the spot welds at the bottom of the doors, but what about the base of the A-, B- and C-pillar to the rear arch? Is it worth trying to cut out the original weld, or should I just lop off the sill in the straightest, neatest cuts I can make and weld them back up afterwards?
Removing Outer Sill to repair Inner
Moderator: martauto
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Further inspection:

Seems I can slice vertically through the outer sill just before the A-pillar, and in front of the C pillar and beam support plate, so that's a minor relief. Still furious about how the bodyshop left the sills in that condition though.

Seems I can slice vertically through the outer sill just before the A-pillar, and in front of the C pillar and beam support plate, so that's a minor relief. Still furious about how the bodyshop left the sills in that condition though.
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Well that's the outer sill open. Still fuming over how bad this got without me knowing:

Check your sills, people!

Check your sills, people!
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Tom_Maverick
- E30 Zone Camper

- Posts: 1343
- Joined: Wed Aug 25, 2010 11:00 pm
- Location: Brighton
wow, it's amazing how these buggers rot right under your nose, a clean car 12 months ago can develop all kinds of nasties! regular checkups are definitely recommended!
looks like it'll be fun to repair.. best of luck!
looks like it'll be fun to repair.. best of luck!

-
bab-91
- Married to the E30 Zone

- Posts: 7174
- Joined: Thu Jan 06, 2011 11:00 pm
- Location: Northern Ireland
Grrrmachine wrote: Check your sills, people!
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
It's not as awful as I thought. It had rusted to about 5mm below the spot welds that hold the floor pan in place, so I was able to run a slit disc along it and get most of the crust off. There's nothing holding the drivers seat up now though 


'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
BATTS91
- E30 Zone Squatter

- Posts: 1764
- Joined: Sat May 01, 2010 11:00 pm
- Location: clacton on sea essex
my thought too im scard to even take headlining away justincade i find horrors lolbab-91 wrote:Grrrmachine wrote: Check your sills, people!
I dont want to look at mine after seeing that!!
