e30 maxes out at 5000 revs

General E30 related discussions -
Please put technical questions in E30 Tech Help forum below

Moderator: martauto

matt86
E30 Zone Addict
E30 Zone Addict
Posts: 2468
Joined: Thu Jan 19, 2012 11:00 pm
Location: "The Cotswolds" Stroud, Gloucestershire

Post Thu Apr 12, 2012 11:11 am

Hi my e30 1.8 convertible maxes out at 5000 revs, is this a fault, or is this what its limited too, I'm just worried I may have a worn camshaft, as it is hesistant too sometimes, was going to give it a full service anyway, but am thinking of doing a engine conversion shortly when I have the money.

Thanks
:)
darkchild
E30 Zone Addict
E30 Zone Addict
Posts: 2729
Joined: Mon Feb 06, 2006 11:00 pm
Location: Kingston 12

Post Thu Apr 12, 2012 11:13 am

matt86 wrote:I'm just worried I may have a worn camshaft
Very likely. Sounds like a typical neglected M40 I'm afraid. :(
User avatar
flybmw
E30 Zone Newbie
E30 Zone Newbie
Posts: 235
Joined: Mon Mar 12, 2012 11:00 pm

Post Thu Apr 12, 2012 11:17 am

I have the same thing. How can I be sure that it is a problem with a camshaft? How can I fix that? Sorry for stupid question.

My car (running M40) revs to 5 000rpm, hesitates and then shift to next gear (Auto tranny). What could be causing it? It does not rev higher than 5k rpms.

Thanks
Rtaylor2208
E30 Zone Addict
E30 Zone Addict
Posts: 3004
Joined: Mon Oct 11, 2010 11:00 pm
Location: Ayr, Ayrshire, Scotland

Post Thu Apr 12, 2012 11:20 am

matt86
E30 Zone Addict
E30 Zone Addict
Posts: 2468
Joined: Thu Jan 19, 2012 11:00 pm
Location: "The Cotswolds" Stroud, Gloucestershire

Post Thu Apr 12, 2012 11:27 am

I think we both have the same issue and need a new or 2nd hand camshaft fitting, I'd say best to try a service first, correct me if I'm wrong.

Was thinking of engine conversion anyway, but how long will it last and will it eventually do long term damage to engine, or will the lobes just be worn, the engine itself in mine is currently quite quiet, no rattles, knocks etc
User avatar
BenHar
E30 Zone Addict
E30 Zone Addict
Posts: 3089
Joined: Sun Jul 11, 2010 11:00 pm
Location: Reigate, Surrey

Post Thu Apr 12, 2012 12:18 pm

matt86 wrote: try a service first
Haven't you done this yet?

Spent all your money on polish?

Ben
pacerpete
E30 Zone Team Member
E30 Zone Team Member
Posts: 18165
Joined: Sun Jan 23, 2005 11:00 pm
Location: Iver heath. South bucks.

Post Thu Apr 12, 2012 12:21 pm

BenHar wrote:
matt86 wrote: try a service first
Haven't you done this yet?

Spent all your money on council bits ?

Ben

:)
matt86
E30 Zone Addict
E30 Zone Addict
Posts: 2468
Joined: Thu Jan 19, 2012 11:00 pm
Location: "The Cotswolds" Stroud, Gloucestershire

Post Thu Apr 12, 2012 12:45 pm

pacerpete wrote:
BenHar wrote:
matt86 wrote: try a service first
Haven't you done this yet?

Spent all your money on council bits ?

Ben

:)
winkeye haha, that was good pete.

Yes Ben didn't get my priorities right, put too much money into tarting the car up, rather than sorting the mechanical side first. next payday in a couple of weeks I will service it, and check everything else over on the car.

It's not being driven at the moment anyway. :thumb:
maggspower
Turbo Farmer Tractor Driver
Posts: 2376
Joined: Wed Oct 12, 2005 11:00 pm
Location: Nowhere near South Wales, ok butt

Post Thu Apr 12, 2012 1:04 pm

I am by no means an expert on the m40 engine, but worn valve springs would cause your problem, and have heard that these can suffer from this, the springs become too weak to close the valves quick enough at high revs causing a symptom called valve bounce. If the valves are not seating as they should you get less compression, one of the key ingredients that an internal combustion engine relies on to produce power.

In truth it is more than likley that the symptoms are caused by wear in multiple components in the valve train and not one specific part, these engine are 20 years old plus, and unless low milage and well looked after they will need perodical maintenance.

HTH