Post
Tue Jan 24, 2012 4:43 pm
Assuming its a sunroof fitted car there are 4 screws which hold it in place around the sunroof aperture - IIRC you need the sunroof panel out to get at the back 2 and they may by hidden under the material where it folds over.
The stainless steel plates which are part of the sunroof surround are razor-sharo so be careful.
Its also held in place by the door rubbers and rear window rubbers.
Prep work is everything before attempting to re-cover the board - you need to remove every trace of the old adhesive & foam backing which is a royal PITA to do because it wont scrape off easily and will clog any sort of abrasive paper in seconds - and forget using any sort of solvent on it if you want your new material to stick properly afterwards.
getting it out isnt too bad but getting a nice minty one back in without damaging it is an endurance test. I wouldnt want to do another one.
Worth it though
Before :

After

Last edited by capri_rob on Tue Jan 24, 2012 4:58 pm, edited 1 time in total.
e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite