Ive had this fault for a year now,and its driving me INSANE!
Moderator: martauto
-
ah
- E30 Zone Addict

- Posts: 2518
- Joined: Mon Mar 10, 2008 11:00 pm
- Location: surrey
My 1990 320i cab has the most annoying fault I've ever known,can someone help.When driving the car around 1k-1.5k it kangaroos,anything after those revs it flys.Also at standstill when you blip the throttle the engine fails to pick IE it dies for a second.On more than one occasion it will not start for about 2 minutes or so,it also seems to be slightly misfiring all the time,but better the faster you go,and it much worst when the car is cold,The things that have been changed and checked so fare are-new fuel filter,new main rubber hose on inlet manifold,all 6 new plugs,new rotor arm +distributor cap,second hand air flow meter+crankcase sensor,new TPC,new temperature Sensor,new HT leads,valve clearance adjusted,checked the multi plug under the inlet manifold seems to be OK.Ive also checked every where for air leaks but cant seem to find any, I had a couple of ideas today and I would like the zones opinion whether you think I may be up the right tree,could it be a knackered fuel injector,or a fuel pump relay, PLEASE PLEASE CAN SOMEONE HELP! as Ive had to live with this fault for the last year months,plus 6 different mechanics to try an find what is wrong but with no success.

Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !)
-
e301988325i
- E30 Zone Addict

- Posts: 3701
- Joined: Fri Feb 01, 2008 11:00 pm
- Location: Taunton, Somerset
1) Throttle position sensor functionality check, three pins, left and middle connected at idle, middle and right connected at full throttle.
2) Get a set of M20 b20 injectors cleaned at injectortune and then swap yours out with the cleaned ones.
3) take the car to a garage for exhaust emission check, Co2 should be 1% at idle, report results.
Best of luck
2) Get a set of M20 b20 injectors cleaned at injectortune and then swap yours out with the cleaned ones.
3) take the car to a garage for exhaust emission check, Co2 should be 1% at idle, report results.
Best of luck
I said:
Can anyone suggest how to test if the boot lights are staying on with the boot shut?
e30topless said:
lock the wife in there
Can anyone suggest how to test if the boot lights are staying on with the boot shut?
e30topless said:
lock the wife in there
-
E30Gheko
- E30 Zone Addict

- Posts: 3789
- Joined: Sun Sep 28, 2008 11:00 pm
- Location: Wirral
my money's on clogged injectors. Easy to remove, and these syptoms should have some degree of visibility on the injectors once removed. Replace all the little o rings too with new ones when refitting.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
e301988325i wrote:1) Throttle position sensor functionality check, three pins, left and middle connected at idle, middle and right connected at full throttle.
2) Get a set of M20 b20 injectors cleaned at injectortune and then swap yours out with the cleaned ones.
3) take the car to a garage for exhaust emission check, Co2 should be 1% at idle, report results.
Best of luck
4) Assorted airleaks on the inlet side, between the air meter and the engine.
1) As well as functionality, it's important that it switches immediately the throttle leaves it's stop. Any delay here will result in a massive flat spot when you press the throttle.
-
kam-325i
- E30 Zone Team Member

- Posts: 4851
- Joined: Tue Sep 27, 2005 11:00 pm
- Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!
TPS not set right and /or Air leak after AFM.ah wrote:Also at standstill when you blip the throttle the engine fails to pick IE it dies for a second
Pete don't care about colour, He would shag a rainbow if he could find the end of it....


-
SGP
- E30 Zone Regular

- Posts: 502
- Joined: Thu Aug 31, 2006 11:00 pm
Ignition coil.
If it ain't broke..
Fix it till it is
Fix it till it is
-
Ajsingh
- E30 Zone Addict

- Posts: 2378
- Joined: Sun Mar 28, 2010 11:00 pm
- Location: West Laaaandaan init! / Milton Keynes
Injectors make a huge differance! Get them refurbed!
E30 Crazy!
-
ah
- E30 Zone Addict

- Posts: 2518
- Joined: Mon Mar 10, 2008 11:00 pm
- Location: surrey
Could it also be knackered DME relay,or Fuel pump/injector relay.
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !)
-
ross2009
- E30 Zone Addict

- Posts: 2762
- Joined: Mon Nov 19, 2007 11:00 pm
- Location: In my beemer MAN !!!! st neots CAMBS
when you say youve checked the multi plug under the inlet did you take the rubber boot of and check the wires ?
or did you just unplug it have a look and put it bk together ?
or did you just unplug it have a look and put it bk together ?
-
ah
- E30 Zone Addict

- Posts: 2518
- Joined: Mon Mar 10, 2008 11:00 pm
- Location: surrey
I looked in the top half and the female side of the top half,but I couldn't see how take off the bottom half from the metal bracket.
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !)
-
ross2009
- E30 Zone Addict

- Posts: 2762
- Joined: Mon Nov 19, 2007 11:00 pm
- Location: In my beemer MAN !!!! st neots CAMBS
just pulls out youll be suprised how much crap that bottom boot collects i only had to move mine and the wires snapped
-
Speedtouch
- Old Skooler

- Posts: 14129
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Have you tried resetting the ECU by disconnecting either it or the battery, leaving it for an hour or so, reconnect then let engine idle for at least 10 minutes, then switch off, then take it for a drive throughout the rev range in all gears.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
-
ah
- E30 Zone Addict

- Posts: 2518
- Joined: Mon Mar 10, 2008 11:00 pm
- Location: surrey
To be honest I haven't tried this.Speedtouch wrote:Have you tried resetting the ECU by disconnecting either it or the battery, leaving it for an hour or so, reconnect then let engine idle for at least 10 minutes, then switch off, then take it for a drive throughout the rev range in all gears.
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !)
-
Speedtouch
- Old Skooler

- Posts: 14129
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Doing it like that ensures that the base idle settings are learnt, then the rest of the mapping info from the EPROM (chip) transferred over.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
-
ah
- E30 Zone Addict

- Posts: 2518
- Joined: Mon Mar 10, 2008 11:00 pm
- Location: surrey
Well am I up the wrong tree.ah wrote:Could it also be knackered DME relay,or Fuel pump/injector relay.
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !)
-
Speedtouch
- Old Skooler

- Posts: 14129
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Could be worth swapping them out for some known good/new ones.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
-
SGP
- E30 Zone Regular

- Posts: 502
- Joined: Thu Aug 31, 2006 11:00 pm
Swapping the coil only takes a few minutes, my m20b20 was playing up for ages before I tried a good coil. Unfortunately this can also damage the ecu.
If it ain't broke..
Fix it till it is
Fix it till it is
-
steinbachphoto
- E30 Zone Newbie

- Posts: 25
- Joined: Mon Nov 01, 2010 11:00 pm
- Location: Victoria, BC, Canada
I'd clean your Idle Control Valve and clean inside your throttle body, you'd be surprised how much sticky crap gets stuck on the valve, mine was a little hesitant at start up and after cleaning the valve it's a lot better.
-
lamby
- E30 Zone Regular

- Posts: 251
- Joined: Wed Jan 27, 2010 11:00 pm
also i would clean your ecu as mine done this,convertible m20,done all the checks,injector clean,afm etc etc took out ecu,wd40 and a toothbrush and ffs run like new.nearly scrapped the thing coz of this.now have several ecu,s.oh and use your partners toothbrush as wd40 tastes crap 
-
parkin10
- E30 Zone Regular

- Posts: 510
- Joined: Mon Sep 17, 2007 11:00 pm
- Location: south yorkshire
i had similar problems to yours
i made all air leaks good especially the vacuum pipes to the servo
had the injectors done (injectortune)
made sure the tps works properly
good luck
i made all air leaks good especially the vacuum pipes to the servo
had the injectors done (injectortune)
made sure the tps works properly
good luck
-
andyf
- E30 Zone Newbie

- Posts: 69
- Joined: Tue Jul 15, 2008 11:00 pm
Ive got a 1989 320i cab and it kangaroos a bit in the low gears and needs to be driven with much higher revs to compensate. In my case its because the cars been fitted with a 4.45 diff instead of the 3.45 standard one. The car pulls 4000 revs at just under 60mph and fuel economy is awful. I suppose the previous owner wanted a faster low down acceleration.
-
manse73
- E30 Zone Camper

- Posts: 1109
- Joined: Sat Mar 20, 2010 11:00 pm
- Location: in a town near you
have the engine running and sprayt wd40 allover the inlet side especially the inlet manifold to head area and listen to engine noise sound difference
and dont be tight with the wd40
this is how i learnt i had and inlet leak, mine was running awful and a new set of inlet gaskets later runs sweet
and dont be tight with the wd40
this is how i learnt i had and inlet leak, mine was running awful and a new set of inlet gaskets later runs sweet
Sebring grey motorsport convertible

