Ive had this fault for a year now,and its driving me INSANE!

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
ah
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Mar 10, 2008 11:00 pm
Location: surrey

Post Wed Jan 11, 2012 8:51 pm

My 1990 320i cab has the most annoying fault I've ever known,can someone help.When driving the car around 1k-1.5k it kangaroos,anything after those revs it flys.Also at standstill when you blip the throttle the engine fails to pick IE it dies for a second.On more than one occasion it will not start for about 2 minutes or so,it also seems to be slightly misfiring all the time,but better the faster you go,and it much worst when the car is cold,The things that have been changed and checked so fare are-new fuel filter,new main rubber hose on inlet manifold,all 6 new plugs,new rotor arm +distributor cap,second hand air flow meter+crankcase sensor,new TPC,new temperature Sensor,new HT leads,valve clearance adjusted,checked the multi plug under the inlet manifold seems to be OK.Ive also checked every where for air leaks but cant seem to find any, I had a couple of ideas today and I would like the zones opinion whether you think I may be up the right tree,could it be a knackered fuel injector,or a fuel pump relay, PLEASE PLEASE CAN SOMEONE HELP! as Ive had to live with this fault for the last year months,plus 6 different mechanics to try an find what is wrong but with no success. :cry: :cry: :cry: :cry:
Image
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !) :cry:
e301988325i
E30 Zone Addict
E30 Zone Addict
Posts: 3701
Joined: Fri Feb 01, 2008 11:00 pm
Location: Taunton, Somerset

Post Wed Jan 11, 2012 8:58 pm

1) Throttle position sensor functionality check, three pins, left and middle connected at idle, middle and right connected at full throttle.
2) Get a set of M20 b20 injectors cleaned at injectortune and then swap yours out with the cleaned ones.
3) take the car to a garage for exhaust emission check, Co2 should be 1% at idle, report results.

Best of luck
I said:

Can anyone suggest how to test if the boot lights are staying on with the boot shut?

e30topless said:

lock the wife in there
E30Gheko
E30 Zone Addict
E30 Zone Addict
Posts: 3789
Joined: Sun Sep 28, 2008 11:00 pm
Location: Wirral

Post Sun Jan 22, 2012 10:13 pm

my money's on clogged injectors. Easy to remove, and these syptoms should have some degree of visibility on the injectors once removed. Replace all the little o rings too with new ones when refitting.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Jan 22, 2012 10:23 pm

e301988325i wrote:1) Throttle position sensor functionality check, three pins, left and middle connected at idle, middle and right connected at full throttle.
2) Get a set of M20 b20 injectors cleaned at injectortune and then swap yours out with the cleaned ones.
3) take the car to a garage for exhaust emission check, Co2 should be 1% at idle, report results.

Best of luck


4) Assorted airleaks on the inlet side, between the air meter and the engine.
1) As well as functionality, it's important that it switches immediately the throttle leaves it's stop. Any delay here will result in a massive flat spot when you press the throttle.
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Sun Jan 22, 2012 10:29 pm

ah wrote:Also at standstill when you blip the throttle the engine fails to pick IE it dies for a second
TPS not set right and /or Air leak after AFM.
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
SGP
E30 Zone Regular
E30 Zone Regular
Posts: 502
Joined: Thu Aug 31, 2006 11:00 pm

Post Mon Jan 23, 2012 12:16 am

Ignition coil.
If it ain't broke..
Fix it till it is :)
Ajsingh
E30 Zone Addict
E30 Zone Addict
Posts: 2378
Joined: Sun Mar 28, 2010 11:00 pm
Location: West Laaaandaan init! / Milton Keynes

Post Mon Jan 23, 2012 7:08 am

Injectors make a huge differance! Get them refurbed!
E30 Crazy!
User avatar
ah
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Mar 10, 2008 11:00 pm
Location: surrey

Post Mon Jan 23, 2012 9:57 pm

Could it also be knackered DME relay,or Fuel pump/injector relay.
Image
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !) :cry:
ross2009
E30 Zone Addict
E30 Zone Addict
Posts: 2762
Joined: Mon Nov 19, 2007 11:00 pm
Location: In my beemer MAN !!!! st neots CAMBS

Post Mon Jan 23, 2012 10:08 pm

when you say youve checked the multi plug under the inlet did you take the rubber boot of and check the wires ?
or did you just unplug it have a look and put it bk together ?
Turbo M20
Image
v8 project 6.0 twin turbo
http://s924.photobucket.com/user/Rossco ... ject%20e30
User avatar
ah
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Mar 10, 2008 11:00 pm
Location: surrey

Post Mon Jan 23, 2012 10:18 pm

I looked in the top half and the female side of the top half,but I couldn't see how take off the bottom half from the metal bracket.
Image
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !) :cry:
ross2009
E30 Zone Addict
E30 Zone Addict
Posts: 2762
Joined: Mon Nov 19, 2007 11:00 pm
Location: In my beemer MAN !!!! st neots CAMBS

Post Mon Jan 23, 2012 10:19 pm

just pulls out youll be suprised how much crap that bottom boot collects i only had to move mine and the wires snapped
Turbo M20
Image
v8 project 6.0 twin turbo
http://s924.photobucket.com/user/Rossco ... ject%20e30
Speedtouch
Old Skooler
Old Skooler
Posts: 14129
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Mon Jan 23, 2012 10:23 pm

Have you tried resetting the ECU by disconnecting either it or the battery, leaving it for an hour or so, reconnect then let engine idle for at least 10 minutes, then switch off, then take it for a drive throughout the rev range in all gears.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
User avatar
ah
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Mar 10, 2008 11:00 pm
Location: surrey

Post Mon Jan 23, 2012 10:29 pm

Speedtouch wrote:Have you tried resetting the ECU by disconnecting either it or the battery, leaving it for an hour or so, reconnect then let engine idle for at least 10 minutes, then switch off, then take it for a drive throughout the rev range in all gears.
To be honest I haven't tried this.
Image
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !) :cry:
Speedtouch
Old Skooler
Old Skooler
Posts: 14129
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Mon Jan 23, 2012 10:43 pm

Doing it like that ensures that the base idle settings are learnt, then the rest of the mapping info from the EPROM (chip) transferred over.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
User avatar
ah
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Mar 10, 2008 11:00 pm
Location: surrey

Post Mon Jan 23, 2012 10:46 pm

ah wrote:Could it also be knackered DME relay,or Fuel pump/injector relay.
Well am I up the wrong tree.
Image
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !) :cry:
Speedtouch
Old Skooler
Old Skooler
Posts: 14129
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Mon Jan 23, 2012 10:50 pm

Could be worth swapping them out for some known good/new ones.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
SGP
E30 Zone Regular
E30 Zone Regular
Posts: 502
Joined: Thu Aug 31, 2006 11:00 pm

Post Tue Jan 24, 2012 1:19 am

Swapping the coil only takes a few minutes, my m20b20 was playing up for ages before I tried a good coil. Unfortunately this can also damage the ecu.
If it ain't broke..
Fix it till it is :)
User avatar
steinbachphoto
E30 Zone Newbie
E30 Zone Newbie
Posts: 25
Joined: Mon Nov 01, 2010 11:00 pm
Location: Victoria, BC, Canada

Post Wed Jan 25, 2012 12:13 am

I'd clean your Idle Control Valve and clean inside your throttle body, you'd be surprised how much sticky crap gets stuck on the valve, mine was a little hesitant at start up and after cleaning the valve it's a lot better.
User avatar
lamby
E30 Zone Regular
E30 Zone Regular
Posts: 251
Joined: Wed Jan 27, 2010 11:00 pm

Post Wed Jan 25, 2012 8:34 pm

also i would clean your ecu as mine done this,convertible m20,done all the checks,injector clean,afm etc etc took out ecu,wd40 and a toothbrush and ffs run like new.nearly scrapped the thing coz of this.now have several ecu,s.oh and use your partners toothbrush as wd40 tastes crap 8O
User avatar
parkin10
E30 Zone Regular
E30 Zone Regular
Posts: 510
Joined: Mon Sep 17, 2007 11:00 pm
Location: south yorkshire

Post Thu Jan 26, 2012 10:17 pm

i had similar problems to yours

i made all air leaks good especially the vacuum pipes to the servo

had the injectors done (injectortune)

made sure the tps works properly

good luck
andyf
E30 Zone Newbie
E30 Zone Newbie
Posts: 69
Joined: Tue Jul 15, 2008 11:00 pm

Post Sun Jan 29, 2012 5:00 pm

Ive got a 1989 320i cab and it kangaroos a bit in the low gears and needs to be driven with much higher revs to compensate. In my case its because the cars been fitted with a 4.45 diff instead of the 3.45 standard one. The car pulls 4000 revs at just under 60mph and fuel economy is awful. I suppose the previous owner wanted a faster low down acceleration.
manse73
E30 Zone Camper
E30 Zone Camper
Posts: 1109
Joined: Sat Mar 20, 2010 11:00 pm
Location: in a town near you

Post Sun Jan 29, 2012 5:17 pm

have the engine running and sprayt wd40 allover the inlet side especially the inlet manifold to head area and listen to engine noise sound difference

and dont be tight with the wd40

this is how i learnt i had and inlet leak, mine was running awful and a new set of inlet gaskets later runs sweet
Sebring grey motorsport convertible