Post
Sun Jan 08, 2012 10:58 am
IIRC, BMW used hex head bolts from two suppliers at the same time. Only bolts from one of the suppliers are prone to fracture, but there is no way of telling which manufacturer made any particular bolt, so the only way of eliminating the suspect bolts is to replace all hex. bolts.
The greater figure a bolt is torqued up to, the greater the error introduced by friction between the bolt head and the washer under it, and between the threads on the bolt and the block.
If you simply torque up the bolts to a final figure, there will be considerable differences between the true tensions in the bolts, which is the path to warped heads and blown/leaking gaskets.
By initially torquing to a much lower figure, where the friction effects are lower, and then angle torquing, the finished result is much more accurate.
As Tay himself says in another thread " There's a massive difference between a mechanic and an engineer!"