Hi Zoners! Hope your all well!
Ive just bought a sunroof motor from a fellow zoner and was wondering how to go about fitting this, i have the front panel aswell with the open/close switch. Any advice wld be brill! Is there any other part i wld need apart from the ones ive already listed?
Thanx
Mitz
Manual to auto sunroof
Moderator: martauto
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Ideally, you need the whole motor assembly and mounting plate, complete with the guide tubes.
It's been a while since I did one of these, but there are subtle differences between the backplates for each type, which at first sight appears to be the same for manual and electric.
The three threaded holes that the motor mounts to do not have quite the correct spacing, and there is a difference in height of one of the mountings.
All this can be overcome (and I did on the first one I ever converted), but it's easier to swap in the whole thing.
It's been a while since I did one of these, but there are subtle differences between the backplates for each type, which at first sight appears to be the same for manual and electric.
The three threaded holes that the motor mounts to do not have quite the correct spacing, and there is a difference in height of one of the mountings.
All this can be overcome (and I did on the first one I ever converted), but it's easier to swap in the whole thing.
-
milescook
- E30 Zone Camper

- Posts: 1285
- Joined: Thu Jan 13, 2011 11:00 pm
- Location: The 'bran of Cwm
Do you have the sunroof motor loom? If not message me I have one spare for only a few notes 
The story so far... http://www.cookracing.co.uk/
Also please help the race budget by watching some videos
https://www.youtube.com/cookracinguk
Also please help the race budget by watching some videos
-
bmw9818
- E30 Zone Addict

- Posts: 2561
- Joined: Tue Aug 11, 2009 11:00 pm
- Location: Croydon
i did mine few years back when i got my one, you need to remove the black plate, grind the rivet and it should pop off, cant remember how it goes, but once you get the old mounting plate off, just line up the new one, think it just bolts to the rail, bronze peice section,
i think the bolts on the guide rail are the same? i used the manual one,
i think the bolts on the guide rail are the same? i used the manual one,
-
MIDNIGHT-RACER
- E30 Zone Newbie

- Posts: 53
- Joined: Sun Dec 04, 2011 11:00 pm
I have the loom, thanx bud... Still sounds like rocket science to me.. Lol
-
Jim320i
- E30 Zone News / COTM Team

- Posts: 10627
- Joined: Sun Oct 25, 2009 11:00 pm
- Location: Leicestershire
I tried removing one the other day. Ended up me loosing my temper and peices being bent up in anger... Good luck putting one in mate! 
-
bmw9818
- E30 Zone Addict

- Posts: 2561
- Joined: Tue Aug 11, 2009 11:00 pm
- Location: Croydon
Lol exactly what I did, pair of pliers bending it to fit, I eventually figured it outJim320i wrote:I tried removing one the other day. Ended up me loosing my temper and peices being bent up in anger... Good luck putting one in mate!
