Alternator mounting bushes

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Sat Jan 07, 2012 9:37 am

I replaced the alternator mounting bushes a few years back with the standard rubber ones. It stopped most of the movement at the time, but I have never realy got it good and firm( the alternator mounting). Any other options been tried? Also, Apart from taking out the air box has anyone found a good way to get strong purchase on the bolts that hold the alternator on?
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Sat Jan 07, 2012 11:17 am

Polybushes are available in the UK....bit expensive,I seem to remember paying £20+ a pair,and you need two pairs,of course.

On the upside,they eliminated movement and enabled me to stop the damn belt from squealing!
Youth is wasted on the young.
User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Sun Jan 08, 2012 1:57 am

20 quid is fine if it sorts the problem. Where did you get them? I will just get some posted out buy the people who sell them.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Jan 08, 2012 10:27 am

Alternator without rubber bushes is the obvious and permanent answer.
What's the problem with the two minute job of taking the airbox out? This is the first thing to do before most work on the LH side of the engine.
User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Sun Jan 08, 2012 10:51 am

There is no problem taking the air box out. I have done it many times. What I meant was is there anything else that I can do in addition to this to get access to the alternator so that I can get plenty of purchase on the bolts? Is there any other part that people remove when working on the alternator? In fact I want to put new crush washers on the banjo fittings on the power steering and I thought about pulling out the radiator and associated pipes just to get better access for both jobs.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Jan 08, 2012 11:05 am

Pulling out the radiator is equally as easy, but leaves you with the job of refilling afterwards.
Steering pump washers (and belt tensioner) are best done from underneath.
User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Mon Jan 09, 2012 4:16 am

Are the crush washers aluminum ?