Alternator mounting bushes
Moderator: martauto
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
I replaced the alternator mounting bushes a few years back with the standard rubber ones. It stopped most of the movement at the time, but I have never realy got it good and firm( the alternator mounting). Any other options been tried? Also, Apart from taking out the air box has anyone found a good way to get strong purchase on the bolts that hold the alternator on?
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Polybushes are available in the UK....bit expensive,I seem to remember paying £20+ a pair,and you need two pairs,of course.
On the upside,they eliminated movement and enabled me to stop the damn belt from squealing!
On the upside,they eliminated movement and enabled me to stop the damn belt from squealing!
Youth is wasted on the young.
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
20 quid is fine if it sorts the problem. Where did you get them? I will just get some posted out buy the people who sell them.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Alternator without rubber bushes is the obvious and permanent answer.
What's the problem with the two minute job of taking the airbox out? This is the first thing to do before most work on the LH side of the engine.
What's the problem with the two minute job of taking the airbox out? This is the first thing to do before most work on the LH side of the engine.
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
There is no problem taking the air box out. I have done it many times. What I meant was is there anything else that I can do in addition to this to get access to the alternator so that I can get plenty of purchase on the bolts? Is there any other part that people remove when working on the alternator? In fact I want to put new crush washers on the banjo fittings on the power steering and I thought about pulling out the radiator and associated pipes just to get better access for both jobs.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Pulling out the radiator is equally as easy, but leaves you with the job of refilling afterwards.
Steering pump washers (and belt tensioner) are best done from underneath.
Steering pump washers (and belt tensioner) are best done from underneath.
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
Are the crush washers aluminum ?
