The car is going in for a roll cage Monday that goes to the front struts. I'll be getting a smaller batter but the fuse box presumably needs to move.
Any tips on this madness? Would it bea easier to move it inside? There's a lot of wires to cut, strip, lenghten, put back together again Would I be okay joining them and sealing with heat shrink?
Thanks a million- not looking forward to this so all advice greatfuly appreciated!
If you undo the brake servo and all of the chassis harness in the engine bay you can swing the fuse box half way down the turret, thats plenty of space!
I would not under any circumstances cut any wires or even consider you are able to put things back together again with some heat shrink!
If it's going to be stripped, then you can undo all the connections and pull the loom out through the bulkhead into the engine bay. But there's no way to relocate the fuse box any more than about six inches from where it currently sits, without massive surgery to the wires, which really isn't recommended.
Cheers I've been able to move it enough out the way of where will go roll cage strut to turret.can't see it fitting halfway down turret? Theres fluid bottle in way.might be able to bolt it in further towards centre after cage is in will post back!
Cheers.
Usual way is remove the whole loom through the hole in the bulkhead then refit it from inside the car with the fusebox mounted in the glovebox area. Lot of faff but gives a clean/tidy engine bay afterwards