Got the chance to buy a fully reconditioned box from a 325 post facelift (might even get rid of that chattering at idle!) but how hard is it to fit into a prefacelift with crank sensors in the bellmouth?
Is it just the holes that need machining out? Are they marked? or is there more to it?
And no, I'm not upgrading the Motronic......
Post facelift 325i box into pre facelift, how hard?
Moderator: martauto
-
clipper
- E30 Zone Squatter

- Posts: 1980
- Joined: Mon Aug 22, 2005 11:00 pm
- Location: Madrid
These are sensations as hard to forget as they are to ignore.....
-
sweep
- Married to the E30 Zone

- Posts: 10110
- Joined: Sat Mar 15, 2008 11:00 pm
- Location: spares & repairs in sheffield
Im unsure about drilling your bell housing mate but if you get stuck i have a early 325i gearbox from a 87 car
-
clipper
- E30 Zone Squatter

- Posts: 1980
- Joined: Mon Aug 22, 2005 11:00 pm
- Location: Madrid
Postage might be an issuesweep wrote:Im unsure about drilling your bell housing mate but if you get stuck i have a early 325i gearbox from a 87 car
These are sensations as hard to forget as they are to ignore.....
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Why not? A days work.clipper wrote: And no, I'm not upgrading the Motronic......
-
e30topless
- E30 Zone Team Member

- Posts: 13595
- Joined: Wed Aug 23, 2006 11:00 pm
- Location: surrounded by scrap
drilling the bell housing is not something i wouldn't rely on working properly,
if i was in your position i would be strongly considering a 1.3 upgrade
if i was in your position i would be strongly considering a 1.3 upgrade

