Post facelift 325i box into pre facelift, how hard?

Need technical Q/A then you're in the right place

Moderator: martauto

clipper
E30 Zone Squatter
E30 Zone Squatter
Posts: 1980
Joined: Mon Aug 22, 2005 11:00 pm
Location: Madrid

Post Mon Dec 19, 2011 8:14 pm

Got the chance to buy a fully reconditioned box from a 325 post facelift (might even get rid of that chattering at idle!) but how hard is it to fit into a prefacelift with crank sensors in the bellmouth?

Is it just the holes that need machining out? Are they marked? or is there more to it?

And no, I'm not upgrading the Motronic......
These are sensations as hard to forget as they are to ignore.....
sweep
Married to the E30 Zone
Married to the E30 Zone
Posts: 10110
Joined: Sat Mar 15, 2008 11:00 pm
Location: spares & repairs in sheffield

Post Mon Dec 19, 2011 8:21 pm

Im unsure about drilling your bell housing mate but if you get stuck i have a early 325i gearbox from a 87 car
clipper
E30 Zone Squatter
E30 Zone Squatter
Posts: 1980
Joined: Mon Aug 22, 2005 11:00 pm
Location: Madrid

Post Mon Dec 19, 2011 11:48 pm

sweep wrote:Im unsure about drilling your bell housing mate but if you get stuck i have a early 325i gearbox from a 87 car
Postage might be an issue :mad:
These are sensations as hard to forget as they are to ignore.....
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Mon Dec 19, 2011 11:49 pm

clipper wrote: And no, I'm not upgrading the Motronic......
Why not? A days work.
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
e30topless
E30 Zone Team Member
E30 Zone Team Member
Posts: 13595
Joined: Wed Aug 23, 2006 11:00 pm
Location: surrounded by scrap

Post Tue Dec 20, 2011 12:06 am

drilling the bell housing is not something i wouldn't rely on working properly,

if i was in your position i would be strongly considering a 1.3 upgrade :D