Best way of removing under carpet tar?
Moderator: martauto
-
hazd31
- E30 Zone Squatter

- Posts: 1689
- Joined: Sat Feb 07, 2009 11:00 pm
- Location: west sussex, nr brighton
As obove, is it just a case of chissleing away or is there a better method?
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Petrol or thinners will soften it up a bit, as will some heat. But yes, it is really a case of thunk thunk thunk with the mallet and chisel.
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
hazd31
- E30 Zone Squatter

- Posts: 1689
- Joined: Sat Feb 07, 2009 11:00 pm
- Location: west sussex, nr brighton
I got shouted at for suggesting a heat gun! Good job for the missus 
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
I was welding the floor a few months back. That softened the surrounding tar enough to peel it away by hand 
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
milescook
- E30 Zone Camper

- Posts: 1285
- Joined: Thu Jan 13, 2011 11:00 pm
- Location: The 'bran of Cwm
Heat gun every day for me - they aren't expensive and make peeling the stuff off effortless. Clean up with some spirts and rag and it works a treat. Just do a quick search for "remove heat shielding" here this is the advice usualy given out.
The story so far... http://www.cookracing.co.uk/
Also please help the race budget by watching some videos
https://www.youtube.com/cookracinguk
Also please help the race budget by watching some videos
-
Alex
- Married to the E30 Zone

- Posts: 22665
- Joined: Fri Feb 11, 2005 11:00 pm
- Location: Johannesburg, South Africa
heat gun 
-
DanThe
- E30 Zone Team Member

- Posts: 28649
- Joined: Sat Sep 10, 2005 11:00 pm
- Location: Staffs
Heat gun, hammer and chisel if your a monkey 
-
bigbird76
- E30 Zone Regular

- Posts: 571
- Joined: Sat Feb 16, 2008 11:00 pm
- Location: Swansea Wales UK
Heat gun and scraper and some patience dont burn it just warm it up in a 6" area and run the scraper under it and just heat up and follow it along.
Did all my M3 that way no hammers or chisels required.
Leigh
Did all my M3 that way no hammers or chisels required.
Leigh
